Difference between revisions of "Mixer / Mackie / CFX MkII"
(first edition) |
|||
| Line 6: | Line 6: | ||
Simplest thing that could possibly work. | Simplest thing that could possibly work. | ||
| − | ''' | + | ''' {{Use1/4}} ''' |
== Outputs == | == Outputs == | ||
| + | |||
XLR Balanced +4 | XLR Balanced +4 | ||
| + | |||
{{TooHotForPS1}} | {{TooHotForPS1}} | ||
XLR Balanced with built-in-pad | XLR Balanced with built-in-pad | ||
| + | |||
{{UsePadSetting}} | {{UsePadSetting}} | ||
&frac1/4 Inch with suitable output for PS1 Powerstand Channel 1 or 2 inputs | &frac1/4 Inch with suitable output for PS1 Powerstand Channel 1 or 2 inputs | ||
| + | |||
{{RunTROrTRSUnbalanced}} | {{RunTROrTRSUnbalanced}} | ||
Revision as of 00:33, 22 August 2006
Mackie CFX Mk II Mixer
Contents
Summary
Simplest thing that could possibly work.
Use the ¼ inch phone jack (Tip-Sleeve) outputs to
- The PS1 Power Stand (Classic) / Model I Channels 1 or 2 if you want to use the Presets and the R1 Remote Tone and Level Controls
OR - The PS1 Power Stand (Classic) / Model I Channels 3 or 4 if you prefer to leave Channels 1 or 2 open for other inputs. You will have to control Tone and relative Level (between the Channels) at your input source, as you do not have this control over Channels 3 and 4 in the PS1 Power Stand (Classic) / Model I or the R1 Remote.
Outputs
XLR Balanced +4
The nominal output of the XLR Balanced Outputs is too high for the XLR inputs on the PS1 Power Stand Channels 1 and 2. If you want to use balanced cables from the Mixer to Channels 1/2 on the L1 Classic or L1 Model I you may need to use a Pad to lower the signal level from the mixer.
{{#Click:Pad|Image:Pad.jpg|Attenuation Pad}}
XLR Balanced with built-in-pad
If the Mixer has a button, switch or adjustment that allows you to attenuate (turn down) the output of the balanced XLR main outs, try the setting with the lower output.
Here is an example (Mackie 1402 VLZ)
Otherwise you may need to use a Pad for each output channel.
&frac1/4 Inch with suitable output for PS1 Powerstand Channel 1 or 2 inputs
You can use TS (Tip Sleeve) unbalanced cables, or TRS (Tip Ring Sleeve) balanced cables, but since the ¼ inch phone connections at the Bose Classic and Model I Power Stand are unbalanced there is no particular benefit using balanced cables.
¼ Inch Tip-Sleeve (unbalanced) to ¼ Inch Tip-Sleeve (unbalanced)
This should work fine.
¼ Inch Tip-Ring-Sleeve (balanced) to ¼ Inch Tip-Sleeve (unbalanced)
This should work fine.
¼ Inch Tip-Ring-Sleeve (balanced) to ¼ Inch Tip-Ring-Sleeve (balanced)
This should also work, but likely no better than a simple ¼ Inch Tip-Sleeve to Tip-Sleeve cable. This is because the ¼ Inch input on the Bose System is Tip-Sleeve (unbalanced) anyway.
Links:
More Notes