T4S Connection to L1 Model I

Classic

T4S

You can connect the T4S ToneMatch mixer to the L1 Classic or L1 Model I, just as you would a T1 ToneMatch Audio Engine. You'll need a ToneMatch Power Supply

There's a slight difference because there are two 1/4 inch (6.3 mm) output jacks on the T4S for Left and Right Outputs.

You've got two ways to handle this:

1. Pan all your inputs to one side (e.g. Right) and connect the T4S Right output to the L1® Classic Channel 3 (try setting the level to about 4)
   
   
   
   OR
   
2. Leave your inputs panned to center (the default setting), and connect
   • T4S Left output to the L1® Classic Channel 3
     try setting the level to about 4
   • T4S Right output to the L1® Classic Channel 4
     try setting the level to about 4

When using a T1 ToneMatch Audio Engine or T4S ToneMatch mixer with the L1® Classic, you don't need to use the R1 Remote.

Stereo

If you want to run a {T4S} with two L1 Model I or L1 Classic

1. On the T4S ToneMatch mixer Pan your inputs left and right as required, but for best results, pan your inputs to one side or the other, but not up the middle
   • T4S Left output to the Left L1 Classic/L1 Model I Channel 3
     try setting the level to about 4
   • T4S Right output to the Right L1 Classic/L1 Model I Channel 3
     try setting the level to about 4

When using a T1 ToneMatch Audio Engine or T4S ToneMatch mixer with the L1® Classic, you don't need to use the R1 Remote.

---