T8S XLR Outputs to House System

The T8S ToneMatch mixer XLR outputs are LINE LEVEL. If the house system mixer XLR inputs are MIC LEVEL, the T8S ToneMatch mixer signal from the XLR outputs will be too hot. There are several ways to get a better match for the levels.

On the house system

Most house system mixers should have one of the three options below.

1. Use the input trim and lower the input sensitivity
   
   • On the house set system, set the input trim so you get a strong input signal without clipping. See the owners manual for the house mixer for details.
     
     
2. Use the MIC/LINE or ATTENUATION switch to lower the input sensitivity to LINE LEVEL
   
   
   
3. Use the 1/4 inch (6.3 mm) Tip-Ring-Sleeve LINE LEVEL input
   
   
   • Use an XLR to 1/4 inch Tip-Ring-Sleeve converter
     >
     

Between the T8S ToneMatch mixer and the house system

Use a -30 dB attenuation Pad to between the T8S and the house system

On the T8S ToneMatch mixer

Use the T8S ToneMatch mixer 1/4 Tip-Ring-Sleeve output

---