Search results

Jump to: navigation, search

There is a page named "Stereo" on this wiki. See also the other search results found.

Page title matches

Page text matches

  • == Stereo Output from Device to Mono {{L1 nl}} == === Stereo Output from Device to Mono {{L1 nl}} ===
    4 KB (634 words) - 16:38, 27 May 2011
  • This article applies to using multiple {{L1}}s in various ways: Stereo, Mono, Distributed Systems. *Stereo (pre-recorded music), the distance between the systems is less critical bec
    8 KB (1,432 words) - 15:37, 23 September 2023
  • The stereo-sum problem is a general problem for all stereo-sample-based digital pianos and it shows up (in varying degrees) on all mon ...nt to schlep the extra gear. Most load-ins are hard enough as it is. Plus, stereo becomes marginal with distance and it gets you away from the localization f
    4 KB (725 words) - 04:26, 10 December 2011
  • ...entional speaker. This has the effect of greatly enhancing the size of the stereo field'''. ...ers too closely together. Not only does the area over which listeners hear stereo sound shrink but you can get undesirable interference effects caused when t
    3 KB (585 words) - 14:49, 13 March 2021
  • .../m/5941073123/r/2481022343#2481022343 Chris-at-Bose: Live or PreRecorded / Stereo and *-Mono in the Bose® Musicians Community Message Boards]</ref> ...dnesday June 7, 2006 a group of us-at-Bose set up in our performance lab a stereo system of 4 L1s and 8 B1s in the same arrangement shown in the photo by Mik
    6 KB (945 words) - 13:27, 8 October 2009
  • ...ive speakers or use headphone jack even while using built-in speaker load. Stereo tube fx loop. Draws from the basic concept of the Bluesmaker amp modificati * Stereo, all-tube recording amp. 1 EL84 (6V6 available) per side. 3 watts per side
    34 KB (5,610 words) - 15:00, 18 January 2021
  • You can run a stereo source to the 1/8 input or the RCA jack inputs. ==== Stereo Sources ====
    2 KB (245 words) - 06:42, 26 March 2017
  • ...be to biamplify the Leslie. A commonly available electronic crossover and stereo power amp would be a great setup with which to experiment. Lastly, a cros ...power amp and a pair of speakers located on either side of the stage. If a stereo PA rig is being used, the mikes can be fed into two channels of the front-o
    42 KB (7,262 words) - 13:29, 2 September 2008
  • == Connect an Analog Stereo Source to an {{L1 nl}} == You can connect the USB input to {{t1r}} Channel 4/5 for a stereo source (computer) AND an analog input to {{t1r}} Channel 4/5 at the same ti
    5 KB (788 words) - 06:27, 2 December 2018
  • Fun Rig: Stereo &mdash; Two [[Media:EV M-12G EDS.pdf|EV M-12G]] (EVM-12L in floor-wedge cab ...ITOR OUT is mono and optionally stereo, while the Stage offers a dedicated stereo MONITOR OUT. Therefore the output source of the MONITOR OUT might require y
    24 KB (3,721 words) - 12:54, 8 August 2023
  • ===Using a stereo mixer with an {{L1}}=== ;General principles for connecting a stereo mixer to the mono input on your {{L1}}.
    8 KB (1,188 words) - 23:23, 8 April 2022
  • ...the Leslie. Again, it<nowiki>’</nowiki>s "art", right? A Crown VFX-2 and stereo power amp would be a great setup with which to experiment. ...power amp and a pair of speakers located on either side of the stage. If a stereo PA rig is being used, the mikes can be fed into two channels of the front-o
    39 KB (6,630 words) - 16:45, 23 March 2011
  • When talking about cables the terms Stereo, Mono, Balanced, Unbalanced refer to applications (how a cable is being use ...ication or you may end up with poor results. For example, if you connect a stereo signal to a balanced input, you may hear very little, or just effects with
    8 KB (1,267 words) - 17:43, 7 February 2023
  • ==== Stereo + Mixer ==== [[Image:F1 Stereo+Mixer.png|600px]]
    20 KB (3,211 words) - 12:46, 29 September 2023
  • You can run a two signals (for example stereo tracks) through a single {{T1}} out to two {{F1}}s. How you do that will de ...fessional Portable Systems forum - Traktor S8 to T1® to Two F1 Systems in Stereo]
    7 KB (1,179 words) - 05:03, 26 March 2017
  • ...{{Model II}}. The recommended approach is to use a {{T1}} connecting your stereo source to Channel 4/5 or by USB if your source is a computer. If you are lo ...with this idea: You should not consider using a Y-adapter to connect your stereo source to the {{Model 1S}} or {{Model II}} Power Stand. For details about t
    2 KB (364 words) - 23:12, 13 July 2014
  • If you need to playback stereo tracks from a USB from your computer, this how you can do it. *the Stereo Left channel goes through Channel 4/5 to Aux and from there to an analog co
    7 KB (1,115 words) - 16:44, 4 September 2023
  • If you need to playback stereo tracks from a USB from your computer, this how you can do it. [[File:T1 Stereo to F1 Model 812s.jpg|400px]]
    5 KB (809 words) - 17:12, 26 December 2017
  • The Analog input is a ¼ inch balanced input jack. Do not connect a stereo source to this input. ==== Can a stereo signal be used with the analog input? ====
    9 KB (1,440 words) - 01:37, 20 May 2021
  • Hilmar-at-Bose talks about the USB interface<ref>Hilmar-at-Bose in the Stereo Operation discussion [http://bose.infopop.cc/eve/forums/a/tpc/f/7521050644/ Hilmar-at-Bose talks about the USB interface<ref>Hilmar-at-Bose in the Stereo Operation discussion [http://bose.infopop.cc/eve/forums/a/tpc/f/7521050644/
    8 KB (1,290 words) - 18:04, 27 March 2019

View (previous 20 | next 20) (20 | 50 | 100 | 250 | 500)