Difference between revisions of "B1 Rotate the Logos"

From Bose Portable PA Encyclopedia
Jump to: navigation, search
m (New page: You can rotate the Bose logo so it is parallel to the floor even if you have turned the B1 on its side. Chuck-at-Bose said, "... Maybe it's my kung fu grip, but I've had good luck with ca...)
 
m
Line 1: Line 1:
 
 
You can rotate the Bose logo so it is parallel to the floor even if you have turned the B1 on its side. Chuck-at-Bose said, "... Maybe it's my kung fu grip, but I've had good luck with carefully pinching the logo and pulling at these points, then rotating 90 degrees:"  
 
You can rotate the Bose logo so it is parallel to the floor even if you have turned the B1 on its side. Chuck-at-Bose said, "... Maybe it's my kung fu grip, but I've had good luck with carefully pinching the logo and pulling at these points, then rotating 90 degrees:"  
  
Line 5: Line 4:
  
 
Be very careful with the fine ends of the logo because they can be easily broken off. You may even try to pull up in the middle with your fingernails on the edge instead of near the ends.  
 
Be very careful with the fine ends of the logo because they can be easily broken off. You may even try to pull up in the middle with your fingernails on the edge instead of near the ends.  
 
Pull the logo straight out about ½ inch before you attempt to turn it. It is spring loaded, and the rear post is square. You have to clear the post (about ½ inch before you can turn it).
 
  
 
<table><tr><td>Go from this</td><td>to this</td></tr>
 
<table><tr><td>Go from this</td><td>to this</td></tr>
Line 13: Line 10:
 
</table>
 
</table>
  
Pull straight out
+
Pull the logo straight out about ½ inch before you attempt to turn it. It is spring loaded, and the rear post is square. You have to clear the post (about ½ inch before you can turn it).
  
 
[[Image:Rotateb103.jpg|640px]]
 
[[Image:Rotateb103.jpg|640px]]
  
Another look. The hole behind the logo is square.
+
Another look.  
 +
 
 +
 
  
 
[[Image:Rotateb104.jpg|640px]]
 
[[Image:Rotateb104.jpg|640px]]

Revision as of 12:37, 17 August 2011

You can rotate the Bose logo so it is parallel to the floor even if you have turned the B1 on its side. Chuck-at-Bose said, "... Maybe it's my kung fu grip, but I've had good luck with carefully pinching the logo and pulling at these points, then rotating 90 degrees:"

B1LogoRotate.jpg

Be very careful with the fine ends of the logo because they can be easily broken off. You may even try to pull up in the middle with your fingernails on the edge instead of near the ends.

Go from thisto this
Rotateb101.jpg Rotateb102.jpg

Pull the logo straight out about ½ inch before you attempt to turn it. It is spring loaded, and the rear post is square. You have to clear the post (about ½ inch before you can turn it).

Rotateb103.jpg

Another look.


Rotateb104.jpg

Make sure that the logo is flush with the grille so that it does not rattle when the music is playing.