PS1 Power Stand / What Do the LEDs Mean

From Bose Portable PA Encyclopedia
Revision as of 12:44, 27 February 2019 by ST (talk | contribs) (Created page with "{{PS1 Power Stand / What Do the LEDs Mean}}")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

L1 Model I This information is applicable to the L1 Model I
Classic This information is applicable to the L1® Classic


Signal/OL LEDs: Channels 1 and 2

SignalOLLED.png

There are two LEDs on the PS1 Power Stand (Classic) / Model I near the Trim knob labelled Signal/OL -- one for Channel 1 and another for Channel 2.

These LEDs indicate when the signal level channel's preamplifier reaches certain important thresholds. The trim controls located near the LEDs adjust the amount of gain in the preamplifier.

The LEDs turn from off → green when the signal level exceeds a small amount.
The LEDs turn from green → red when the signal reaches a level that's about 10 dB below a level that would clip the preamp and cause objectionable distortion.

When the LED is off (but you are playing an instrument you think is connected to the PS1 or singing/talking into a microphone you think is connected): Increase the level of the trim control. If the LED still does not turn green or red, check instrument/microphone and cables to the PS1.

When you see green only: This indicates that there's some signal in the channel but not enough. While singing or playing the loudest you ever plan to in the performance, increase the trim level until the LED is only flickering red. This is the optimal gain.

When you see red most of the time: Decrease the trim level until you see only flickering red. This is the optimal gain.


Phantom Power LEDs: Channels 1 and 2

Phantom Power LED and Switch

The LEDs near the Phantom Power button are either off or red when phantom power is turned on. — more information about Phantom Power

Power / System Status LED

This LED normally is a steady green when the power is on.

Power LED

If it is not lit or if it is yellow/amber, contact Support.

Note: This LED may briefly flicker yellow /amber when the power is first turned on; this is normal. Within a couple of seconds, it should settle to a steady green.