Difference between revisions of "Securing the T1® to the Microphone Stand Bracket"
m |
m |
||
| Line 9: | Line 9: | ||
| − | This is how I secure the T1® to the [[T1 ToneMatch® Audio Engine / Microphone Stand Bracket|T1® Microphone Stand Bracket]] | + | This is how I secure the T1® to the [[T1 ToneMatch® Audio Engine / Microphone Stand Bracket|T1® Microphone Stand Bracket]]<ref>Original discussion about [http://bose.infopop.cc/eve/forums/a/tpc/f/3976055944/m/9370021626?r=3300035626#3300035626 using the T1® Microphone stand adapter]</ref> |
# There is a velcro strap on the black ToneMatch cable. | # There is a velcro strap on the black ToneMatch cable. | ||
| Line 18: | Line 18: | ||
# Finally, I set the T1® on top of the bracket. | # Finally, I set the T1® on top of the bracket. | ||
| − | + | ||
[[Image:T1 Strapped 02.png]] | [[Image:T1 Strapped 02.png]] | ||
Revision as of 11:12, 24 January 2014
- The bracket that sits parallel to the floor has a bevel on the top. The bevel should run down, facing you. If the bevel runs down away from you, the bracket is upside down and the T1 ToneMatch® Audio Engine will not sit properly on top of it.
- correct - bevel running down, facing you
- incorrect (upside down)- bevel on opposite side, away from you
This is how I secure the T1® to the T1® Microphone Stand Bracket[1]
- There is a velcro strap on the black ToneMatch cable.
- I use the velcro to secure the ToneMatch cable to the microphone stand just above the Microphone Stand Adapter (the thing that clamps around the mic stand).
- Then I insert the ToneMatch cable into the T1®. It locks into place.
- At this point, most people would put the T1® on the bracket and attach the other cables.
- I insert all the other cables into the T1® before I put it on the bracket. I do it this way because I have all my cables strapped to the microphone stand (I don't take them off between gigs). So there's no hanging stress from those either.
- Finally, I set the T1® on top of the bracket.
In the picture above, I am using all the inputs and the cables are heavy. But since I have all the cables secured by a velcro strap, there's no chance that the T1® will come off the microphone stand bracket.
The white cable is a network cable (Cat-5) instead of the ToneMatch® cable
— source
— source
Comments? Please join the discussion on the Bose L1® Forum
- ↑ Original discussion about using the T1® Microphone stand adapter