Securing the T1® to the Microphone Stand Bracket

From Bose Portable PA Encyclopedia
Revision as of 13:40, 18 February 2013 by ST (talk | contribs)
Jump to: navigation, search
  • The bracket that sits parallel to the floor has a bevel on the top. The bevel should run down, facing you. If the bevel runs down away from you, the bracket is upside down and the T1 ToneMatch® Audio Engine will not sit properly on top of it.


This is how I secure the T1® to the T1® Microphone Stand Bracket

  1. There is a velcro strap on the black ToneMatch cable.
  2. I use the velcro to secure the ToneMatch cable to the microphone stand just above the Microphone Stand Adapter (the thing that clamps around the mic stand).
  3. Then I insert the ToneMatch cable into the T1®. It locks into place.
  4. At this point, most people would put the T1® on the bracket and attach the other cables.
  5. I insert all the other cables into the T1® before I put it on the bracket. I do it this way because I have all my cables strapped to the microphone stand (I don't take them off between gigs). So there's no hanging stress from those either.
  6. Finally, I set the T1® on top of the bracket.

T1 Strapped 02.png

In the picture above, I am using all the inputs and the cables are heavy. But since I have all the cables secured by a velcro strap, there's no chance that the T1® will come off the microphone stand bracket.


T1 Strapped 01.png

The white cable is a network cable (Cat-5) instead of the ToneMatch® cable


source

source: http://bose.infopop.cc/eve/forums/a/tpc/f/7521050644/m/1640046046?r=5190039046#5190039046

source