Solo

This is guide for people who use their Bose Portable PA in Solo applications. In addition to the notes below that apply to Solo shows, check out: Downloads Is your equipment up to date? L1® Unofficial Users' Guide Feedback / Microphone Troubleshooting Different Models — Identifying your L1® Terminology & Concepts — This is a comprehensive list of terms that you will encounter as you read about Bose Portable PA.

How do I protect the L1^® components - Cases

Hardshell Cases — this page is about protecting the L1^® components while in transit.

How do I connect an Analog Stereo Source to an L1^®

Backing Tracks — This article covers connecting devices like CD, DVD, mp3, iPods to your L1®

L1^® Model II: Can I run a Stereo Source to the Power Stand

A ¼ inch Tip-Ring-Sleeve connector carrying a stereo signal should not be used with the analog input on the Model II.

Even though a ¼ inch Tip-Ring-Sleeve connector can carry a stereo signal this is not how this physical connection is used on the Solo Power Stand.

The analog input on the Model II is balanced, and will therefore subtract the Left and Right signals on a stereo cable and you will hear an L-R (Left minus Right) signal in the Model II.

You cannot 'get through the gig' this way if you are a DJ or if you need to run prerecorded music or have stereo inputs.

Using a Mixer

If you are using a mixer instead of a T1 ToneMatch Audio Engine use the mixer to create a mono output and send that to the Model II Power Stand Analog input.

• If there is a stereo/mono switch then use it and send the mono output to the Model II Power Stand Analog input.
• If there is a Left/mono output then use that and send it to the Model II Power Stand Analog input.
• If there is no way to create a mono output then pan all your mixer inputs all the way to one side (e.g. Left) and then take the mixer for that side (e.g. Left) output and send it to the Model II Power Stand Analog input.

---