Difference between revisions of "T1 ToneMatch® Audio Engine / Connections to Compact"

From Bose Portable PA Encyclopedia
Jump to: navigation, search
m (T1®s to Separate Inputs on Compact Channel 2)
m (Daisy Chain Two T1®s to Compact Channel 2)
Line 21: Line 21:
 
[[Image:T1x2IntoCompact02.png]]
 
[[Image:T1x2IntoCompact02.png]]
  
 +
 +
====Compact Channel 2 detail====
 +
 +
[[Image:Compact Channel 2 Line Level.png]]
  
 
<noinclude>For more general information see:  {{T1}} and {{Compact}}
 
<noinclude>For more general information see:  {{T1}} and {{Compact}}

Revision as of 06:20, 20 July 2013

T1 This information is applicable to the T1 ToneMatch® audio engine
L1 Compact

There are several possibilities for connecting a T1 ToneMatch Audio Engine to a L1 Compact


T1® to Compact Channel 2

You can connect a T1 ToneMatch Audio Engine to L1 Compact


Here is an excerpt from page 12 of the L1® Compact Owner's Guide (pdf format)

CompactOwnersGuideT1Connection.gif

Connect FROM T1 ToneMatch Audio Engine Master or Aux Output using ¼ inch jack connections.

Connect TO the Compact Channel 2 volume straight up (12:00 o'clock to 1:00 o'clock) for good results. You can turn it up higher, but if you see the light on the Compact solid red (flickers of red are okay) or you hear distortion, turn down the volume on the Compact.


¼ Inch Tip-Ring-Sleeve (balanced) to ¼ Inch Tip-Ring-Sleeve (balanced)

A balanced connection is preferred and will provide better noise rejection over greater distances than the unbalanced connection.

Tip-Ring-Sleeve to Tip-Ring-Sleeve

¼ Inch Tip-Ring-Sleeve (unbalanced) to ¼ Inch Tip-Sleeve (unbalanced)

This should work fine but a balanced connection (immediately above) is preferred especially if you will have cable runs in excess of 20 feet (6 meters) or if you hear line noise, hum or hiss.

Tip-Sleeve to Tip-Sleeve



Channel 2 Connection from T1 ToneMatch Audio Engine Details

Connect the T1 ToneMatch Audio Engine Master output L1 Compact channel 2.

T1MasterOutput.png

Compact Channel 2 Line Level.png

Turn the Channel 1 volume all the way down (fully counterclockwise) unless you have a microphone attached to it.



Two T1®s to a Single Compact

T1®s to Separate Inputs on Compact Channel 2

T1x2IntoCompact01.png

Compact Channel 2 detail

Compact Channel 2 Line Level and RCA.png

Daisy Chain Two T1®s to Compact Channel 2

T1x2IntoCompact02.png


Compact Channel 2 detail

Compact Channel 2 Line Level.png

For more general information see: T1 ToneMatch Audio Engine and L1 Compact