Difference between revisions of "T1 ToneMatch® Audio Engine / Parametric EQ / Solving Problems"
|Line 17:||Line 17:|
Adjust the '''Width''' control to as narrow a value as possible, so that only the problem is being affected, leaving the non-offending frequencies around it unchanged. The T1 goes down to ''one fifth'' (0.20) of an octave, which is great for 'notching out' problem notes. <br />
Now adjust the '''Level'' control to cut (turn down) enough to make the problem go away, but not so much that the tone of the source is altered in an undesirable way. Values of -1 to -6 dB will often do the trick, though sometimes a more aggressive cut is necessary. Use your ears to find an appropriate balance between fixing the problem and adversely altering the tone of the source.
Revision as of 17:09, 10 July 2007
Troubleshooting with the T1 ToneMatch Audio Engine Parametric EQ
Using Para EQ to solve a problem frequency
In this example a Bassist was having a problem with a resonant note (B flat).
Chuck-at-Bose provided this approach.
4. Adjust the Width control to as narrow a value as possible, so that only the problem is being affected, leaving the non-offending frequencies around it unchanged. The T1 goes down to one fifth (0.20) of an octave, which is great for 'notching out' problem notes.
Hilmar-at-Bose had a different approach
Here is one method to eliminate a boomy note
a) set the level of the para EQ to a cut, say -10 dB
b) set the width to fairly narrow, say .25 octaves
c) start with a rough estimate of the offending frequency and then move the frequency around until the offending note gets tamed best
d) you can press on the level control to toggle between on and off which gives you a direct A/B so you can judge the effect better
Once you have centered on the frequency you adjust the level and width to taste.
Estimating the frequency:
- Low octave of the bass is from 40 Hz to 80 Hz (E1 to E2), A1 is at 55 Hz
- Low octave on the guitar is from 80 Hz to 160 Hz (E2 to E3), A2 is at 110 Hz
- 2nd octave on the guitar is from 160 Hz to 320 Hz (E3 to E4), A3 is at 220 Hz
Here is a cheat sheet http://www.phy.mtu.edu/~suits/notefreqs.html
Hope that helps