T8S XLR Outputs to House System

From Bose Portable PA Encyclopedia
Revision as of 10:50, 24 April 2019 by ST (talk | contribs)
Jump to: navigation, search

T8S Outputs XLR.jpg

The T8S ToneMatch mixer XLR outputs are LINE LEVEL. If the house system mixer XLR inputs are MIC LEVEL, the T8S ToneMatch mixer signal from the XLR outputs will be too hot. There are several ways to get a better match for the levels.

Most house system mixers should have one of the three options below.

On the house system
  • Use the input trim and lower the input sensitivity
    Mixer Input Trim.jpg
    • On the house set system, set the input trim so you get a strong input signal without clipping. See the owners manual for the house mixer for details.


  • Use the MIC/LINE or ATTENUATION switch to lower the input sensitivity to LINE LEVEL
    Mixer Input Pad Switch.jpg
  • Use the 1/4 inch (6.3 mm) Tip-Ring-Sleeve LINE LEVEL input
    Allen Heath 60 10FX Inputs.jpg
    • Use an XLR to 1/4 inch Tip-Ring-Sleeve converter
      MP-105 600w DETAILw.jpg>
Between the T8S ToneMatch mixer and the house system
  • Use a -30 dB attenuation Pad to between the T8S and the house system
    Find them on the web



On the T8S ToneMatch mixer