T8S to L1 Model II

Connect the T8S to L1 Model II

Use 1/4 inch (6 mm) Tip-Ring-Sleeve cables.

Connect the ToneMatch Power Supply to the T8S ToneMatch mixer for power.

Set the L1 Model II Analog Input Trims to about 9:00 o'clock.

Gain Staging

For each L1 Model II

L1 Model II Analog Input

The Analog input is a ¼ inch balanced input jack.

Analog input trim (volume, or gain) control

There is a trim control for the analog input.

1. Set the Trim control on the power stand to the 0 (zero) position.
2. Connect the T8S ToneMatch mixer Main Output to the Analog Input
3. Adjust the volume of the T8S ToneMatch mixer Main Output to the maximum output without distortion. This is probably between 10:00 o'clock and 12:00 o'clock on the Master Output
4. While playing the source, increase the Trim level so that the Signal/Clip indicator glows green or yellow. This will probably be around 9:00-11:00 o'clock
5. If the Signal/Clip indicator glows red, decrease the Trim level so that it glows only green or yellow.

---