View source for Template:ToneMatch Mixers to F1 Model 812

<!--
#Plug in your ToneMatch mixer and F1 812 to power and then connect the audio path using an XLR or TRS ¼-inch cable.
#Power on the devices.
#Set the F1 812 switch to Line Level and turn up the Volume knob to the 12 o’clock center detent.
#Set the ToneMatch mixer Master output to 10 o’clock. --> <!-- This is the mixer’s unity output.-->  <!--
#Set ToneMatch Trim controls and set the input volumes as high as possible without input clipping. You can use the Prefs | Input Level on the ToneMatch mixer to monitor the input level.
#Unmute the channels on the ToneMatch mixer and adjust your channel volumes to stay between 0 dB and +6 dB at the master output. You can monitor this visually on the T8S LED or in the Prefs | Output Level on the ToneMatch mixer.

-->

== Gain Staging ==
For each {{F1}} 

=== {{F1}} Channel 1 Combo Input  ===
The use an XLR or  ¼ inch Tip-Ring-Sleeve jack cable. 

=== MIC / LINE LEVEL ===
Set this to LINE LEVEL


==== Volume Control  ====
Use the Input 1 volume control.

[[File:F1 812 Channel 1 only.png]]

# Set the Input 1 '''Volume''' control to the 0 (zero) position.
# Connect the {{T8S}} Main Output to the Input 1
# Adjust the volume of the {{T8S}} Main Output to the maximum output without distortion. This is probably between 10:00 o'clock and 12:00 o'clock on the Master Output
# While playing music through the {{T8S}}, increase the '''Volume''' level so that the '''Signal/Clip''' indicator glows green with flickers of red. This will probably be around 9:00-11:00 o'clock
# If the '''Signal/Clip''' indicator glows red, decrease the '''Volume''' level so that it glows only green or red. If you see red flashes longer than one second, turn down the volume.

----
[[Category:F1]]
[[Category:T4S]]
[[Category:T8S]]