View source for T1® to Denon DN-X500

T1®  to Denon DN-X500

Connection an {{T1}} to a Denon DN-X500

There are three connections on the Denon DN-X500 where you could connect a {{T1}} Master or Aux output.

==== {{T1}} to Denon DN-X500 microphone input ====
The T1® Master Output is a line level output. You can raise and lower that with the Master Volume control.

The Denon DN-X500 has level controls for both the Main Mic and Aux Mic inputs. 

Start with the master output of the T1® all the way off and bring it up slowly. You will also want to have the DN-X500 microphone input level set quite low to start until you figure out the levels so that you don't have any clipping.

[[Image:DN-X500Input4T1.png]]

==== Notes that apply to all three approaches ====
You'll need a [[T1_ToneMatch%C2%AE_Audio_Engine_power_supply|T1 ToneMatch%C2%AE Audio Engine power supply]][[Image:T1_power_supplyThumb.jpg]]       

The T1® Master Output is a line level output. You can raise and lower that with the Master Volume control to get a good level match to the input that you use on the Denon-DNX500.

Make the connection with a &frac14; inch jack Tip-Ring-Sleeve cable.

[[Image:TrsMtrsM.png]]

==== {{T1}} to Denon DN-X500 microphone input ====



Start with the master output of the T1® all the way off and bring it up slowly. You will also want to have the DN-X500 microphone input level set quite low to start until you figure out the levels so that you don't have any clipping.

The Denon DN-X500 has level controls for both the Main Mic and Aux Mic inputs. 

Start with the master output of the T1® all the way off and bring it up slowly. You will also want to have the DN-X500 microphone input level set quite low to start until you figure out the levels so that you don't have any clipping.

This is a screen shot of English page 3 with an overlay of the back of the T1® &Xi;&Theta;&infin;&ni;--


[[Image:DN-X500Input4T1-Aux.png]]

==== {{T1}} to Denon DN-X500 Effects Return ====
This could give you a better match for levels and impedance, but you will have to control everything with the T1®. Start with the master output of the T1® all the way off and bring it up slowly. 
	
[[Image:DN-X500Input4T1-EffectsReturn.png]]

Reference Notes: [http://usa.d-mpro.com/DocumentMaster/US/f1160bc969bf42e0bc5e90b6600c5207.pdf Denon DN-X500 User Manual] 

http://usa.d-mpro.com/DocumentMaster/US/f1160bc969bf42e0bc5e90b6600c5207.pdf

----
[[Category:Denon]]
[[Category:Mixer]]
[[Category:Denon DN-X500]]
[[Category:T1]]