Difference between revisions of "Mixer / Yamaha / MG8/2FX"
(added notes for MG10/2) |
m (Category:Yamaha) |
||
Line 54: | Line 54: | ||
[[category:Mixer]] | [[category:Mixer]] | ||
+ | |||
+ | [[Category:Yamaha]] |
Revision as of 23:05, 21 October 2006
Yamaha MG8/2FX Mixer and MG10/2 Mixer
Contents
Summary
Simplest thing that could possibly work.
Use the ¼ inch phone jack (Tip-Sleeve) outputs to the PS1 Powerstand, Channels 1 or 2 if you want to use the presets and the Tone and Level Controls on the R1 Remote
Outputs
¼ Inch with suitable output
for PS1 Powerstand Channel 1 or 2 inputs
You can use TS (Tip Sleeve) unbalanced cables, or TRS (Tip Ring Sleeve) balanced cables, but since the ¼ inch phone connections at the Bose Classic and Model I Power Stand are unbalanced there is no particular benefit using balanced cables.
¼ Inch Tip-Sleeve (unbalanced) to ¼ Inch Tip-Sleeve (unbalanced)
This should work fine.
¼ Inch Tip-Ring-Sleeve (balanced) to ¼ Inch Tip-Sleeve (unbalanced)
This should work fine.
¼ Inch Tip-Ring-Sleeve (balanced) to ¼ Inch Tip-Ring-Sleeve (balanced)
This should also work, but likely no better than a simple ¼ Inch Tip-Sleeve to Tip-Sleeve cable. This is because the ¼ Inch input on the Bose System is Tip-Sleeve (unbalanced) anyway.
Links:
- MG8/2FX Manual
- MG10/2 Manual
- From page 18 of the manual (19 for the MG10/2)
Specifications for the MG10/2, MG82FX
OUTPUT CHARACTERISTICS MG8/2FX Connection Actual Source Impedance For Use With Nominal Output Level *1 Connector In Mixer Nominal Max. before Clip ST OUT [L, R] 150 Ω 10 kΩ Lines +4 dBu (1.23 V) +24 dBu (12.3 V) Phone Jack (TRS) *6 AUX SEND 150 Ω 10 kΩ Lines +4 dBu (1.23 V) +20 dBu (7.75 V) Phone Jack (TRS) *6 CH INSERT OUT (1 – 2) 150 Ω 10 kΩ Lines 0 dBu (0.775 V) +20 dBu (7.75 V) Phone Jack (TRS) *5 2TR OUT [L, R] 600 Ω 10 kΩ Lines -10 dBV (245 mV) +10 dBV (2.45 V) RCA Pin Jack
More Notes