Mixer / Yamaha / MG124 CX

To use a Yamaha MG124 CX Mixer with the L1 Model II

Overview

On the mixer

• Pan all the inputs hard LEFT
• Run a line out of the LEFT output to the Model II Power Stand Analog input (cable details below)

Settings on the L1® Input Panel

Start off with the Input Trim at 3 and adjust if necessary so that the Signal/OL light stays green most of the time. Occasional flickers of yellow are okay. If it is flickering or solid red, turn down the Input Trim.

¼ inch jack inch to ¼ inch

This mixer has ¼ inch jack balanced outputs. Any of the cables shown below should work. ¼ Inch Tip-Ring-Sleeve (balanced) to ¼ Inch Tip-Ring-Sleeve (balanced) The output of this mixer is balanced, and the input on the Model II Power Stand is also balanced, so this is the preferred method. ¼ Inch Tip-Sleeve (unbalanced) to ¼ Inch Tip-Sleeve (unbalanced) ¼ Inch Tip-Ring-Sleeve (balanced) to ¼ Inch Tip-Sleeve (unbalanced)

Documents

• L1 Model II
• Yamaha MG124CX/MC124 Owner's Manual

---