Difference between revisions of "L1® Compact / Connection from a Mixer"
m (first ed) |
m (→Cables) |
||
| Line 1: | Line 1: | ||
Summary: You need a mono output from the mixer to {{Compact}} Channel 2 | Summary: You need a mono output from the mixer to {{Compact}} Channel 2 | ||
| − | === Cables === | + | You can used ¼ inch jack cables. Balanced or unbalanced will work fine. '''DO NOT use a stereo''' ¼ inch jack Tip-Ring-Sleeve connection. You may suffer significant signal loss. If you must make a stereo connection then use the 1/8 inch stereo connection or the RCA jack inputs. |
| + | |||
| + | |||
| + | === ¼ inch jack Cables === | ||
| − | |||
{{#lst:T1 ToneMatch® Audio Engine / 1/4 inch Output Connections to L1® Family Members|Balanced}} | {{#lst:T1 ToneMatch® Audio Engine / 1/4 inch Output Connections to L1® Family Members|Balanced}} | ||
| − | |||
=== Channel 2 Connection from {{T1}} Details === | === Channel 2 Connection from {{T1}} Details === | ||
Revision as of 12:28, 15 December 2009
Summary: You need a mono output from the mixer to L1 Compact Channel 2
You can used ¼ inch jack cables. Balanced or unbalanced will work fine. DO NOT use a stereo ¼ inch jack Tip-Ring-Sleeve connection. You may suffer significant signal loss. If you must make a stereo connection then use the 1/8 inch stereo connection or the RCA jack inputs.
Contents
¼ inch jack Cables
¼ Inch Tip-Ring-Sleeve (balanced) to ¼ Inch Tip-Ring-Sleeve (balanced)
A balanced connection is preferred and will provide better noise rejection over greater distances than the unbalanced connection.
¼ Inch Tip-Ring-Sleeve (unbalanced) to ¼ Inch Tip-Sleeve (unbalanced)
This should work fine but a balanced connection (immediately above) is preferred especially if you will have cable runs in excess of 20 feet (6 meters) or if you hear line noise, hum or hiss.
Channel 2 Connection from T1 ToneMatch Audio Engine Details
