Mixer / Yamaha / MG124 CX

From Bose Portable PA Encyclopedia
Revision as of 14:02, 19 September 2012 by ST (talk | contribs) (Settings on the L1® Input Panel)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search
To use a Yamaha MG124 CX Mixer with the L1 Model II


Overview

On the mixer

  • Pan all the inputs hard LEFT
  • Run a line out of the LEFT output to the Model II Power Stand Analog input (cable details below)

YamahaMG124 to Model II Power Stand Analog Input.png

Settings on the L1® Input Panel

Start off with the Input Trim at 3 and adjust if necessary so that the Signal/Clip light stays green most of the time. Occasional flickers of yellow are okay. If it is flickering or solid red, turn down the Input Trim.

ModelIIInputsForTwoLT1.png

Cable Details

¼ inch jack inch to ¼ inch

This mixer has ¼ inch jack balanced outputs. Any of the cables shown below should work.


¼ Inch Tip-Ring-Sleeve (balanced) to ¼ Inch Tip-Ring-Sleeve (balanced)

The output of this mixer is balanced, and the input on the Model II Power Stand is also balanced, so this is the preferred method.

Tip-Ring-Sleeve to Tip-Ring-Sleeve

¼ Inch Tip-Sleeve (unbalanced) to ¼ Inch Tip-Sleeve (unbalanced)

Tip-Sleeve to Tip-Sleeve

¼ Inch Tip-Ring-Sleeve (balanced) to ¼ Inch Tip-Sleeve (unbalanced)

Tip-Ring-Sleeve to Tip-Sleeve


Documents

YamahaMG124 Output.png