Difference between revisions of "S1 Pro to L1 Model II"

From Bose Portable PA Encyclopedia
Jump to: navigation, search
m (:Balanced TRS from S1 to Model II)
m (:Balanced TRS from S1 to Model II)
Line 26: Line 26:
 
[[File:Model II Analog Input Level Green.png]]
 
[[File:Model II Analog Input Level Green.png]]
  
|Additional Information
+
|Additional Information=
 
;Cable Information
 
;Cable Information
  

Revision as of 20:53, 19 October 2018

If you want to use your S1 Pro System as a monitor and use an L1 Model II as the Front of House system you can connect your microphone and instrument to the S1 Pro System and connect the S1 Pro System to the L1 Model II


How To

Connect S1 Pro System to L1 Model II

You can connect to the S1 Pro system as you would when using it without additional equipment. Then run a cable from the S1 Pro Line Out

The S1 Pro System Line Out is post Volume, Tone, and ToneMatch presets on channels 1 and 2. It also includes the post volume signal from channel 3.

S1 Pro Line Out


to the

L1 Model II Analog input 1/4 inch (6.35 mm) Tip-Ring-Sleeve. Use an 1/4 inch (6.35 mm) Tip-Ring-Sleeve cable.

Model II Analog Input Trim.png

  1. Set the Trim control on the power stand to the 0 (zero) position.
  2. Connect the audio source to the Analog Input
  3. Adjust the volume of the audio source to the maximum output without distortion.
  4. While playing the source, increase the Trim level so that the Signal/Clip indicator glows green or yellow.
  5. If the Signal/Clip indicator glows red, decrease the Trim level so that it glows only green or yellow.

Model II Analog Input Level Green.png

Additional Information

Cable Information

Balanced TRS from S1 to Model II

You can use an 1/4 inch (6.35 mm) Tip-Sleeve cable but you may lose up to -6dB