S1 Pro to L1 Model II

From Bose Portable PA Encyclopedia
Revision as of 19:53, 19 October 2018 by ST (talk | contribs) (:Balanced TRS from S1 to Model II)
Jump to: navigation, search

If you want to use your S1 Pro System as a monitor and use an L1 Model II as the Front of House system you can connect your microphone and instrument to the S1 Pro System and connect the S1 Pro System to the L1 Model II

How To

Connect S1 Pro System to L1 Model II

You can connect to the S1 Pro system as you would when using it without additional equipment. Then run a cable from the S1 Pro Line Out

The S1 Pro System Line Out is post Volume, Tone, and ToneMatch presets on channels 1 and 2. It also includes the post volume signal from channel 3.

S1 Pro Line Out

to the

L1 Model II Analog input 1/4 inch (6.35 mm) Tip-Ring-Sleeve. Use an 1/4 inch (6.35 mm) Tip-Ring-Sleeve cable.

Model II Analog Input Trim.png

  1. Set the Trim control on the power stand to the 0 (zero) position.
  2. Connect the audio source to the Analog Input
  3. Adjust the volume of the audio source to the maximum output without distortion.
  4. While playing the source, increase the Trim level so that the Signal/Clip indicator glows green or yellow.
  5. If the Signal/Clip indicator glows red, decrease the Trim level so that it glows only green or yellow.

Model II Analog Input Level Green.png

Additional Information

Cable Information

Balanced TRS from S1 to Model II

You can use an 1/4 inch (6.35 mm) Tip-Sleeve cable but you may lose up to -6dB