T1® Audio Engine / Master Output Pre / Post

From Bose Portable PA Encyclopedia
Revision as of 22:21, 20 March 2013 by ST (talk | contribs)
Jump to: navigation, search

When using the T1 ToneMatch Audio Engine for recording or when sending a signal to an external system, it may be useful to set the Master Output to Pre-Master Volume. This sends the full output of the T1 ToneMatch® Audio Engine directly to

  • the Master Analog ¼ inch jack


This puts the control of the signal at the receiving end (external system or computer).

But be careful if you have an L1® or other device connected to the T1® Master Output. The signal will be Pre-Master. That is... loud.

Here is how you change the Master Output from Pre-Master Volume (the default) to Post-Master Volume.

T1MasterOutputPrePost01.png

T1MasterOutputPrePost02.png

T1MasterOutputPrePost03.png