Difference between revisions of "T1 ToneMatch® Audio Engine / 1/4 inch Output Connections to L1® Family Members"
m |
m (→Model II) |
||
| Line 34: | Line 34: | ||
| − | === Model II === | + | === Model II or Compact === |
==== ¼ Inch Tip-Ring-Sleeve (balanced) to ¼ Inch Tip-Sleeve (unbalanced) ==== | ==== ¼ Inch Tip-Ring-Sleeve (balanced) to ¼ Inch Tip-Sleeve (unbalanced) ==== | ||
This should work fine. | This should work fine. | ||
| Line 50: | Line 50: | ||
---- | ---- | ||
[[Category:T1]] | [[Category:T1]] | ||
| + | [[Category:Classic]] | ||
| + | [[Category:Compact]] | ||
| + | [[Category:Model I]] | ||
| + | [[Category:Model II]] | ||
Revision as of 10:33, 28 April 2009
Connecting from a T1 ToneMatch Audio Engine ¼ inch jack (Master or Aux) to a L1 Classic, L1 Model I or L1 Model II is simple.
Contents
Overview
You can use TS (Tip Sleeve) unbalanced cables, OR TRS (Tip Ring Sleeve) balanced cables. If the cable uses ¼ inch jack plugs and the ends are the same, then the cable should be fine.
OR
Classic or Model I
¼ Inch Tip-Sleeve (unbalanced) to ¼ Inch Tip-Sleeve (unbalanced)
This should work fine.
¼ Inch Tip-Ring-Sleeve (balanced) to ¼ Inch Tip-Ring-Sleeve (balanced)
Since the ¼ inch phone connections at the Bose Classic and Model I Power Stand are unbalanced there is no particular benefit using balanced cables but there is no harm.
Model II or Compact
¼ Inch Tip-Ring-Sleeve (balanced) to ¼ Inch Tip-Sleeve (unbalanced)
This should work fine.
¼ Inch Tip-Ring-Sleeve (balanced) to ¼ Inch Tip-Ring-Sleeve (balanced)
This should also work, and provided better noise rejection over greater distances than the unbalanced connection above.