Difference between revisions of "T1 ToneMatch® Audio Engine to Compact"
m |
m |
||
| Line 6: | Line 6: | ||
[[Image:CompactOwnersGuideT1Connection.gif]] | [[Image:CompactOwnersGuideT1Connection.gif]] | ||
| − | + | Connect FROM {{T1}} Master or Aux Output using ¼ inch jack connections. | |
| − | + | Connect TO the [[L1%C2%AE_Compact#Channel_2|Compact Channel 2]] volume straight up (12:00 o'clock to 1:00 o'clock) for good results. You can turn it up higher, but if you see the light on the Compact flickering red, turn down the volume on the Compact. | |
<!-- | <!-- | ||
[[T1_ToneMatch%C2%AE_Audio_Engine_/_1/4_inch_Output_Connections_to_L1%C2%AE_Family_Members#L1.C2.AE_Compact|T1® to Compact]] | [[T1_ToneMatch%C2%AE_Audio_Engine_/_1/4_inch_Output_Connections_to_L1%C2%AE_Family_Members#L1.C2.AE_Compact|T1® to Compact]] | ||
| Line 18: | Line 18: | ||
=== Channel 2 Connection from {{T1}} Details === | === Channel 2 Connection from {{T1}} Details === | ||
[[Image:Compact Channel 2 Line Level.png]] | [[Image:Compact Channel 2 Line Level.png]] | ||
| + | |||
| + | <noinclude>For more general information see: {{T1}} and {{Compact}} | ||
| + | ---- | ||
| + | [[Category Compact]] | ||
| + | [[Category T1]] | ||
| + | |||
| + | |||
| + | </noinclude> | ||
Revision as of 11:51, 21 August 2011
You can connect a T1 ToneMatch Audio Engine to L1 Compact
From page 12 of the L1® Compact Owner's Guide (pdf format)
Connect FROM T1 ToneMatch Audio Engine Master or Aux Output using ¼ inch jack connections.
Connect TO the Compact Channel 2 volume straight up (12:00 o'clock to 1:00 o'clock) for good results. You can turn it up higher, but if you see the light on the Compact flickering red, turn down the volume on the Compact.
¼ Inch Tip-Ring-Sleeve (balanced) to ¼ Inch Tip-Ring-Sleeve (balanced)
A balanced connection is preferred and will provide better noise rejection over greater distances than the unbalanced connection.
¼ Inch Tip-Ring-Sleeve (unbalanced) to ¼ Inch Tip-Sleeve (unbalanced)
This should work fine but a balanced connection (immediately above) is preferred especially if you will have cable runs in excess of 20 feet (6 meters) or if you hear line noise, hum or hiss.
Channel 2 Connection from T1 ToneMatch Audio Engine Details
For more general information see: T1 ToneMatch Audio Engine and L1 Compact