T1 ToneMatch® Audio Engine to Compact

From Bose Portable PA Encyclopedia
Revision as of 06:27, 20 July 2013 by ST (talk | contribs)
Jump to: navigation, search


T1 ToneMatch Audio Engine to L1 Compact

Here is an excerpt from page 12 of the L1® Compact Owner's Guide (pdf format)

CompactOwnersGuideT1Connection.gif

Connect FROM T1 ToneMatch Audio Engine Master or Aux Output using ¼ inch jack connections.

Connect TO the Compact Channel 2 volume straight up (12:00 o'clock to 1:00 o'clock) for good results. You can turn it up higher, but if you see the light on the Compact flickering red, turn down the volume on the Compact.


¼ Inch Tip-Ring-Sleeve (balanced) to ¼ Inch Tip-Ring-Sleeve (balanced)

A balanced connection is preferred and will provide better noise rejection over greater distances than the unbalanced connection.

Tip-Ring-Sleeve to Tip-Ring-Sleeve

¼ Inch Tip-Ring-Sleeve (unbalanced) to ¼ Inch Tip-Sleeve (unbalanced)

This should work fine but a balanced connection (immediately above) is preferred especially if you will have cable runs in excess of 20 feet (6 meters) or if you hear line noise, hum or hiss.

Tip-Sleeve to Tip-Sleeve



Channel 2 Connection from T1 ToneMatch Audio Engine Details

Compact Channel 2 Line Level.png


Two T1®s to a Single Compact

Two T1®s to Separate Inputs on Compact Channel 2

T1x2IntoCompact01.png

Compact Channel 2 detail

Compact Channel 2 Line Level and RCA.png

Suggested by Tom the Guitar Guy[1]

Daisy Chain Two T1®s to Compact Channel 2

T1x2IntoCompact02.png


Compact Channel 2 detail

Compact Channel 2 Line Level.png


  1. Tom the Guitar Guy in the Bose L1® Forum


For more general information see: T1 ToneMatch Audio Engine and L1 Compact