Template:L1 Model II Analog Input Gain Staging

L1 Model II Analog Input

The Analog input is a 1/4 inch (6.3 mm) Tip-Ring-Sleeve balanced input jack.

Analog input trim (volume, or gain) control

Setting the trim level on the Model II Power Stand is a one-time step. Once you have matched the output of the ToneMatch mixer to the input of the L1 you don't need to adjust it again.

T4S/T8S ToneMatch Mixers

1. Connect the source device Main Output to the L1 Model II Analog Input
2. Set the Analog Input trim to 9:00 o'clock. Control the volume with the Master Volume on the ToneMatch mixer.
   
   If you set the input trim higher, you will have excessive line noise.
3. If the Signal/Clip indicator glows red, decrease the Trim level so that it glows only green or yellow.

For other mixers

1. Set the Trim control on the power stand to the 0 (zero) position.
2. Connect the source device Main Output to the L1 Model II Analog Input
3. Adjust the volume of the source device Main Output to the reference or nominal output level.
   • On analog consoles this may be marked as unity or 0 dB.
   • On digital consoles this may be marked as -18 dBFS. The exact value (-18 dBFS to -20 dBFS) may vary depending your location.
   • Refer to the manual for the source device for details.
4. If the Signal/Clip indicator glows red, decrease the Trim level so that it glows only green or yellow.

---