Difference between revisions of "Template:S1 Pro Mixer Settings"

From Bose Portable PA Encyclopedia
Jump to: navigation, search
(Created page with "On the S1 Pro System, for each channel you are connecting to the mixer use these settings while you are setting up. 500px * Reverb OF...")
 
m
 
Line 11: Line 11:
  
 
=== Gain Staging ===
 
=== Gain Staging ===
For each channel you are using on the S1 Pro System,
+
{{S1 Pro Gain Staging}}
# Turn the channel volume off
 
# Connect your sound source
 
# Set the source outputs (mixer, instruments) to the maximum you will use during your performance.
 
# While playing/singing as loud as you will during your performance, bring up the channel volume until you see solid green on the channel indicator light. Occasional flickers of red are okay. If you see solid red or you hear distortion, turn down the volume.
 
 
 
 
----
 
----
 
[[Category:S1]]
 
[[Category:S1]]
 
[[Category:Mixer]]
 
[[Category:Mixer]]

Latest revision as of 00:58, 10 June 2018

On the S1 Pro System, for each channel you are connecting to the mixer use these settings while you are setting up.

S1 Pro Settings for mixer.jpg

  • Reverb OFF
  • Bass at 12:00 o'clock
  • Treble at 12:00 o'clock
  • ToneMatch switch OFF

You can adjust the Reverb, Bass, and Treble after you get your basic sound working.

Gain Staging

Using a Bose device as the source

When connecting a ToneMatch Mixer[1] or an S1 Pro System Line Out to an S1 Pro System channel 1 or channel 2

Set the volume control to 10:00 o'clock with 1/4 inch (6.3 mm) Tip-Ring-Sleeve

The signal strength from a ToneMatch Mixer[1] or an S1 Pro System Line Out is sufficient to achieve the maximum usable volume from the S1 Pro System
Control the overall volume from the ToneMatch Mixer[1] or the first S1 Pro System. If you use an XLR cable, set the volume control to 9:00 o'clock

ToneMatch Mixer to S1 Pro.jpg


Using a third-party source (not a Bose device as the source)

For each channel you are using on the S1 Pro System

  1. Turn the channel volume off
  2. Connect your sound source
  3. Adjust the volume of the source device output to the reference or nominal output level.
    • On analog consoles this may be marked as unity or 0 dB.
    • On digital consoles this may be marked as -18 dBFS[2][3]. The exact value (-18 dBFS to -20 dBFS) may vary depending your location[4].
    • Refer to the manual for the source device for details.
    • If the source device does not have metering or indicators, set the output as high as you can without hearing distortion or seeing red indicator lights.
  4. While playing/singing as loud as you will during your performance, bring up the channel volume until you see solid green on the channel indicator light. Occasional flickers of red are okay. If you see solid red or you hear distortion, turn down the volume.