Difference between revisions of "Template:T1 ToneMatch® Audio Engine power supply"

From Bose Portable PA Encyclopedia
Jump to: navigation, search
m
m
 
Line 19: Line 19:
 
See: [[T1 ToneMatch® Audio Engine / Connections to Model II|Connecting Two T1®s to a Model II]] for details.
 
See: [[T1 ToneMatch® Audio Engine / Connections to Model II|Connecting Two T1®s to a Model II]] for details.
  
----
 
Close up of the connector that goes to the {{T1}}, just in case you damage the cable and have to replace the connector.
 
  
Note:  The picture is taken with the flat side facing the camera. The release clip is on the other side.
 
 
[[Image:T1 Power Supply RJ 45 Connector.jpg|thumb|Close up of the RJ45 connector]]
 
  
 
----
 
----

Latest revision as of 14:37, 17 April 2020

This is the power supply for the ToneMatch mixers (T1 ToneMatch Audio Engine and T4S/T8S ToneMatch® Mixers).

The T8S ships with a ToneMatch power supply because the T8S cannot draw power from an L1 Model 1S or L1 Model II Power Stand.

You will need the ToneMatch power supply to power your T1 or T4S mixer when running with an L1 Classic, L1 Model I, L1 Compact, S1 Pro System or non-Bose equipment. You will need a one of these if you have two ToneMatch mixers running into a single L1® Model II or L1® Model 1S. — details below the picture.

ToneMatch power supply

Click image above for purchasing details.


If you connect your T1 ToneMatch Audio Engine or T4S mixer to a L1 Model II or L1 Model 1S then the T1 ToneMatch® Audio Engine or T4S draws its power through the ToneMatch cable.

If you connect your ToneMatch mixer to an an L1 Classic, L1 Model I, L1 Compact or S1 Pro System or non-Bose equipment then you will need the ToneMatch power supply


If you are attaching two ToneMatch mixers to a single L1® Model II or L1 Model 1S then you will need this power supply to support the second ToneMatch mixer - the one connected to the Power Stand Analog Input.

See: Connecting Two T1®s to a Model II for details.