Difference between revisions of "Template:T1 ToneMatch® Audio Engine to Model II and Compact"

From Bose Portable PA Encyclopedia
Jump to: navigation, search
m
m
Line 10: Line 10:
 
<html><div style="padding:15px; margin:10px; max-width:500px;"></html>
 
<html><div style="padding:15px; margin:10px; max-width:500px;"></html>
 
<big>   
 
<big>   
Please note: Bose recommends that if you have two {{{Model|Model 1S}}} systems using the same source, that you place the {{{Model|Model 1S}}} systems at least 20 feet apart (6 meters). This is to avoid  [[Multiple_Source_Interference|Multiple Source Interference]]   
+
Please note: Bose recommends that if you have two {{L1}} systems using the same source, that you place the {{{Model|Model 1S}}} systems at least 20 feet apart (6 meters). This is to avoid  [[Multiple_Source_Interference|Multiple Source Interference]]   
 
</big>
 
</big>
 
<html></div></html>
 
<html></div></html>

Revision as of 18:33, 7 March 2015

Usage:

{{T1 ToneMatch® Audio Engine to Two L1®s
|Model=Model II
}}

T1 This information is applicable to the T1 ToneMatch® audio engine
L1 Model 1S This information is applicable to the L1®  Model 1S
L1 Model II This information is applicable to the L1®  Model II
L1 Compact
Please note: Bose recommends that if you have two L1 systems using the same source, that you place the Model 1S systems at least 20 feet apart (6 meters). This is to avoid Multiple Source Interference

Running a Model 1S system and L1 Compactwith the same source is running Dual Mono and not recommended unless the L1®s are at least 20 feet apart. Also, when using a full sized L1® and a Compact, if the Compact is really close to the full sized system, you may not notice much of the sound of the Compact.

T1TwoModelIIandCompact.png

System 1

Connect the first system with the ToneMatch cable that came with the T1®.

  • T1® ToneMatch port to the Model 1S Power Stand ToneMatch port.
Compact

Connect the Compact with a ¼ inch jack Tip-Ring-Sleeve cable

  • T1® Master Output to the L1 Compact Channel 2 input.
    Compact Channel 2 Line Level2.png
    • Set the Channel 2 volume "5" and adjust as necessary to get a good balance with the other system.
    • If you are seeing red on the Channel 2 LED light, turn down the volume on the Compact.
    • If you are using Compact Channel 1, turn the Channel 1 volume all the way off.
    • For best results use a Tip-Ring-Sleeve (balanced) connection.
      TrsMtrsM.png
      You can use a Tip-Sleeve (unbalanced connection) but the Tip-Ring-Sleeve (balanced connection is preferred).