L1 Pro Emergency Kit
Jump to navigation
Jump to search
These are extras and spares I carry in addition to the items I know I will need at a gig.
| Item | Reason |
|---|---|
| IEC Power Cord | They got lost, and this can be used with an XLR cable to substitute for a SubMatch Cable |
| XLR cable | It's always good to have a spare. Use with an IEC Power Cord to replace a SubMatch Cable |
| 1/4-inch (6.3mm) Tip-Ring-Sleeve Cable | Connect mixers or devices with balanced connections to the L1 Pro. |
| 1/4-inch (6.3mm) Tip-Sleeve Cable | This is your basic instrument cable. It's always good to have a spare. |
| XLR Female to 1/4-inch (6.3mm) Tip-Ring-Sleeve Cable | To connect Line Level Output from an L1 Pro or third-party mixer to Channel 3 input of an L1 Pro or S1 Pro+ |
| 1/8-inch (3.5 mm) Tip-Ring-Sleeve Cable | Use this to connect the headphone output of a consumer device to L1 Pro or S1 Pro(+) channel 3 input |
| CAT5 cable | Connect ToneMatch Mixers (T1/T4S/T8S) to the L1 Pro ToneMatch Port |
| ToneMatch Power Supply | In case I need to run two ToneMatch Mixers to a single L1 Pro |
| Dynamic Microphone | This is a spare; the one to use when you have guest speakers making announcements |
| Microphone Clip | They break |
| Multi-bit Screwdriver | Tighten, loosen, everything as needed |
| Gaffers Tape | Tie down cables, or quick repairs |
| Labels with contact information | I have labels on all my gear, but it's good to have spares in case they fall off |