View source for L1® Line Outs

<table><tr>
<td valign="top" width="250">__TOC__</td>
<td valign="top">''' Summary'''

If you need to send your sound out to an external system (remote speaker system, recording, powered loudspeaker) these notes are for you.

* [[{{PAGENAME}}#L1.C2.AE_Compact|The Compact]] was designed with a blended line out (both &frac14; inch jack and RCA).
* [[{{PAGENAME}}#L1® Model I L1® Classic|The Model I / Classic]] have lines out for Channels 1 and 2 only, but no single output for all inputs.
* [[{{PAGENAME}}#L1® Model II|The Model II]] does not have a line out but you can use your signal source.

See the links to the left for notes on each of these systems.
</td>
</tr></table>  

== {{Compact}}  ==
{{Compact icon}}

{{#lst:L1® Compact|Line Out}}

== {{Model I}} {{Classic}} ==
{{Classic icon}}{{Model I icon}}
{{#lst:PS1 Powerstand Connections / Line Out|Connections}}

== {{Model II}} ==
{{Model II icon}}

There is no full range line out of the {{Model II}}.

To run a signal to an external monitor or powered speaker system you need to take that signal from the same source that you are using for the Model II Power Stand.

* Use a {{T1}} and tap the signal from the 
** [[T1_ToneMatch%C2%AE_Audio_Engine#.C2.BC_inch_jack_Output_Connections|Analog Master Output]] 
** [[T1 ToneMatch® Audio Engine / Aux]] 

* Use an external mixer

----
[[Category:Connections]]
[[Category:Compact]]
[[Category:Classic]]
[[Category:Model I]]
[[Category:Model II]]