View source for Template:ToneMatch Mixers to F1 Model 812

#Plug in your ToneMatch mixer and F1 812 to power and then connect the audio path using an XLR or TRS ¼-inch cable.
#Power on the devices.
#Set the F1 812 switch to Line Level and turn up the Volume knob to the 12 o’clock center detent.
#Set the ToneMatch mixer Master output to 10 o’clock. <!-- This is the mixer’s unity output.-->
#Set ToneMatch Trim controls and set the input volumes as high as possible without input clipping. You can use the Prefs | Input Level on the ToneMatch mixer to monitor the input level.
#Unmute the channels on the ToneMatch mixer and adjust your channel volumes to stay between 0 dB and +6 dB at the master output. You can monitor this visually on the T8S LED or in the Prefs | Output Level on the ToneMatch mixer.

----
[[Category:F1]]
[[Category:T4S]]
[[Category:T8S]]