View source for Mixer / Yamaha / MX12/4

<!-- Use this an an outline for a mixer page -->
<!-- Please link to external images, do not upload them to the server -->
<!-- Naming convention
Mixer/Make/Model
e.g.
Mixer/Mackie/DFX12
 -->
<big>''' Yamaha MX12/4 '''</big>

== Summary ==
Simplest thing that could possibly work.



''' {{Use1/4}} ''' 

or 

''' {{UseXLR}} '''
But you will probably want to use a [[Pad]] for each channel.
== Outputs ==
<!-- delete anything that is not applicable -->
=== XLR Balanced +4 === 

{{TooHotForPS1}}
<!--
=== XLR Balanced with built-in-pad === 

{{UsePadSetting}}
-->
=== &frac14; Inch with suitable output===
for PS1 Powerstand Channel 1 or 2 inputs

The &frac14; inch Console should work fine directly into the {{PS1}} Channels 1/2/3/4. Note: this output is [[TRS|Tip-Ring-Sleeve]] (stereo output) so you will need a Tip-Ring-Sleeve to two Tip-Sleeve patch cord to maintain the  separation of the left and right channels. <br />[[Image:InsertCable.gif]]

This Mixer also has Four group outputs (busses). Note that the 'sends' are pre-fader. 

* Page 6 in the Manual showing outputs. #6 highlighted are the &frac14; inch group outputs. <br />[[Image:YamahaMX124Out2.gif]]

{{RunTROrTRSUnbalanced}}


Links:
* [http://www2.yamaha.co.jp/manual/pdf/pa/english/mixers/MX12_4E.pdf Yamaha MX12/4 Manual]
* Page 6 in the Manual showing outputs. #7 highlighted is the Stereo Console out. <br />[[Image:YamahaMX124Out1.gif]]

* Page 6 in the Manual showing outputs. #5 highlighted are the [[XLR]] balanced outputs. These output +4 dBU nominal and are likely too hot for direct input to the XLR inputs on the {{PS1}}. Use [[Pad]]s.<br />[[Image:YamahaMX124Out3.gif]]


More Notes

Reading the manual it is not clear (to me) if you can use the internal effects while routing outputs through the groups 1-4.


----
<references/>

[[category:Mixer]]