View source for T1 ToneMatch® Audio Engine / Routing for Effects

<table><tr>
<td valign="top" width="250">__TOC__</td>
<td valign="top">
This article addresses some interesting options you have for routing your signal through the T1® to process effects more than once.

For ideas on how you can work with an external effects unit see: [[T1 ToneMatch® Audio Engine / Insert for External Effects]]

</td>
</tr></table>  

There are several less than obvious things you can do with effects through the {{T1}}. 
=== Parallel Effects  ===

If you want to swap between two sets of effects or run two sets of effects at the same time (for example: two delays, two modulation effects, two reverbs)&nbsp; try this. 

Assume that you are using Channel 1 as the input where you want to do this: 

*Set the effects you want on Channel 1 
*Take a ¼ inch jack cable from the Channel 1 PreAmp Out to Channel 2 input 
*Add the second layer of effects you want to Channel 2 
*Now use the FX Mute buttons for Channels 1 and 2 to set which banks of effects will be used 
**Channel 1 only 
**Channel 2 only<br> 
**Channel 1 and Channel 2 in parallel<br>

=== Serial Effects  ===

If you want to run some effects and then add more effects in series then take the output of one or more {{T1}} Channels to the Aux Output, then take the Aux Output and use that as the input to another T1® Channel

Assume that you are using Channel 1 as the input where you want to do this:<br> 

*Set the effects that you want on Channel 1 
*Set the '''Aux''' tap to '''Pre''' 
*Take a ¼ inch jack cable from the Aux Out to Channel 2 input 
*Apply effects that you want applied to the output of Channel 1 
*Now use the FX Mute buttons for Channels 1 and 2 to set which banks of effects will be used 
**Channel 1 only 
**Channel 2 only<br> 
**Channel 1 and Channel 2 in series<br>

=== Foot Switch to Mute Effects<br>  ===

From Andy-at-Bose UK<br> 
<blockquote>First up hook up your vocal mic to, say, Channel 1 on the T1®. Next take a jack lead and connect it to the PRE AMP out on Channel 1. Take this lead and run it through either a keyboard style volume pedal or a make or break style footswitch. Run the signal from the pedal/footswitch into another T1® channel and set this channel up with the chosen vocal effects but make them 100% effect. Adjust the effected channel volume to get the desired blend of dry vocal to effected vocal. The pedal/footswitch will determine how much or if any signal will go to channel 2 and therefore whether or not an effect is added.<br> </blockquote> 
[http://bose.infopop.cc/eve/forums/a/tpc/f/8221072574/m/5991023595?r=9991094595#9991094595 Original Post]<br> 

<br> 
<noinclude>
<br> 

This article is a stub. Please help us if you can by expanding it. 
----
[[Category:T1]]
[[Category:Effects]]
</noinclude>