View source for T8S to One L1 Model II

{{T8S icon}}{{Model II icon}}
<div class="tocdiv">
    <div>__TOC__</div>
    <div><h2>Introduction</h2>
Connect a {{T8S}} to a single {{Model II}} or {{Model 1S}}   

Connect the ToneMatch Power Supply to the {{T8S}} for power. 

Always use the ToneMatch Power Supply connected to the {{T8S}} ToneMatch port.

Do not use the ToneMatch port to connect to a {{Model II}}. The {{T8S}} draws more power than the {{Model II}} can supply.              
    </div>
</div>  
 

Connect the ToneMatch Power Supply to the {{T8S}} for power.

== Connect the T8S to {{Model II}} ==
=== 1/4 inch (6.3 mm) Tip-Ring-Sleeve Output===

[[File:T8S to L1 Model II x 1.png|600px]]

{{Balanced TRS from T8S to L1 Model II}}

OR

=== XLR Output ===

[[File:T8S to L1 Model II x 1 XLR.png|600px]]

{{
Balanced XLR |Source= [[T8S]] |Target= {{Model II}} 
}}

{{T8S Mono Output}}


== {{Model II}} Analog Input  ==
The Analog input is a ¼ inch balanced input jack.

[[Image:Model 1S Analog Input Detail.png]] 


==== Analog input trim (volume, or gain) control  ====

Set the {{Model II}}  Analog Input trim control to match the output of the {{T8S}}.


[[Image:Model II Analog Input Trim.png]]

# Set the '''Trim''' control on the power stand to the 9:00 o'clock position.<br>[[File:L1 Model II Analog Input for T4S T8S.png]]
# Connect the {{T8S}} Main Output to the Analog Input
# Adjust the volume of the {{T8S}} Main Output to the maximum output without distortion. This is probably between 10:00 o'clock and 12:00 o'clock on the Master Output
<!-- # While playing the source, increase the '''Trim''' level so that the '''Signal/Clip''' indicator glows green or yellow. This will probably be around 9:00-11:00 o'clock on the {{model II}} analog input trim-->
# If the '''Signal/Clip''' indicator glows red, decrease the '''Trim''' level so that it glows only green or yellow.

[[Image:L1 Model II Analog Input for T4S T8S.png|Model II Analog Input]] 
----
[[Category:T8S]]
[[Category:Model II]]