View source for Template:T1 ToneMatch® Audio Engine to Two L1®s

<noinclude>
Usage:
<pre>
{{T1 ToneMatch® Audio Engine to Two L1®s
|Model=Model II
}}
</pre>
</noinclude>
{{T1 icon}}{{Model 1S icon}}{{Model II icon}}
<big>  
Please note: Bose recommends that if you have two {{{Model|Model 1S}}} systems using the same source, that you place the {{{Model|Model 1S}}} systems at least 20 feet apart (6 meters). This is to avoid  [[Multiple_Source_Interference|Multiple Source Interference]]  
</big>

Running two {{{Model|Model 1S}}} systems with the same source is running [[Dual Mono]] and not recommended unless the L1®s are at least 20 feet apart.

[[Image:T1TwoModelII.png]]
<table width=1000><tr>
<td width=400 valign=top>
;System 1
Connect the first system with the ToneMatch cable that came with the T1®. 
* T1® ToneMatch port to the {{{Model|Model 1S}}} Power Stand ToneMatch port.
</td>
<td style="width:400px;vertical-align:top">
;System 2
Connect the second system with a &frac14; inch jack Tip-Ring-Sleeve cable
* T1® Master Output to the {{{Model|Model 1S}}} Power Stand Analog input 
** on the {{{Model|Model 1S}}}  Power Stand  set the analog input trim to "3" and adjust as necessary to get a good balance with the other system.
** For best results use a Tip-Ring-Sleeve (balanced) connection. <br />[[Image:TrsMtrsM.png]]<br />You can use a Tip-Sleeve (unbalanced connection) but the Tip-Ring-Sleeve (balanced connection is preferred).
</td></tr>
</table>

==== Model II Analog input trim (volume, or gain) control  ====
There is a trim control for the analog input.

[[Image:Model II Analog Input Trim.png]]

# Set the '''Trim''' control on the power stand to the 0 (zero) position.
# Connect the T1 Master Output to the Analog Input using a 1/4 inch (6mm) Tip-Ring-Sleeve cable
# Adjust the volume of the audio source to the maximum output without distortion.
# While playing music through the T1®, increase the '''Trim''' level so that the '''Signal/Clip''' indicator glows green or yellow.
# If the '''Signal/Clip''' indicator glows red, decrease the '''Trim''' level so that it glows only green or yellow.

[[Image:Model II Analog Input Level Green.png|Model 1S Analog Input]] 

Set the input trim to 10:00 - 11:00 o'clock to get results similar to the other L1® connected through the ToneMatch port.

==Stereo ==

{{:T1 ToneMatch® Audio Engine / Stereo Output to Two L1®s}}
----
[[Category:T1]]
[[Category:Model 1S]]
[[Category:Model II]]

[[Category:Connections]]