Search results

Create the page "Delay" on this wiki! See also the search results found.

• Feedback / Microphone
  If you are using vocal effects like reverb, chorus, or delay, turn them off until you can get sufficient [[Gain Before Feedback|gain bef
  16 KB (2,433 words) - 20:03, 1 July 2023
• Comb Filtering
  ...ls, one delayed in time relative to the other, are added. Depending on the delay time, the resulting summed signal can sound hollow or “boingy”, and is
  753 bytes (106 words) - 11:51, 29 September 2007
• Presets - Finding What Works
  ...I would run a relatively clean sound with no effects (no reverb, chorus or delay). You are listening for tone.
  5 KB (858 words) - 11:55, 13 April 2011
• Bose L1® Musicians Conference Fall 2006/Gear
  * Ibanez TS9 Tube Screamer (stock), MXR Micro Amp (pre LED), Boss DD3 Digital delay, Lexicon LXP1 / [[User:Chuck-at-Bose|Chuck-at-Bose]]
  4 KB (568 words) - 18:35, 26 March 2017
• Latency and The L1®
  ...nds or ms for short. 1 ms is the time it takes sound to travel one foot. A delay of 1ms is equivalent to moving one foot away from the loudspeaker or instru
  2 KB (323 words) - 23:12, 25 February 2021
• T1 ToneMatch® Audio Engine / Effects
  .... You can use different combination of compressor/limiter, chorus/flanger, delay, parametric EQ, etc. on each channel. The only thing that is shared is reve
  2 KB (360 words) - 04:45, 26 March 2017
• T1 ToneMatch® Audio Engine / Aux
  ...dynamic processors, 4 modulators (chorus flanger, phaser, etc.) , 4 EQs, 4 delay processors, etc. The only exception is the reverb, which is shared by all c
  5 KB (923 words) - 20:02, 9 July 2018
• Tonematch Mixers / Compressor
  The other effects (Mod, Delay) and Reverb operate the same way. You can only choose one function within t
  7 KB (1,047 words) - 15:58, 16 June 2019
• T1 ToneMatchâ„¢ Audio Engine/Digital Delay for Second L1â„¢
  #REDIRECT [[T1 ToneMatch® Audio Engine / Digital Delay for Second L1®]]
  73 bytes (10 words) - 12:06, 14 March 2008
• South Atlantic States L1® Conference 2008
  * 1 - Pedal board with various pedals (Wah, TubeScreamer, delay, etc.) - Steve-at-Bose
  19 KB (3,088 words) - 18:40, 26 March 2017
• Slap Echo
  ...aced in a different spatial location in the stereo mix. Normally, the echo delay is just large enough to be heard as a discrete echo on careful listening (e
  1 KB (175 words) - 05:00, 30 April 2008
• FX Mute
  FX Mute specifically mutes: Delay, Mod (Chorus, Flange,Phaser,Trem) and Reverb.
  307 bytes (43 words) - 22:27, 2 August 2011
• Microphone Feedback
  * If you are using vocal effects like reverb, chorus or delay, turn them off until you can get sufficient [[Gain Before Feedback|gain bef
  3 KB (528 words) - 16:12, 7 January 2009
• PorchBoard Floor Bass UCL-S (discontinued in 2010)
  * no noise, feedback or delay
  1 KB (149 words) - 14:46, 9 February 2010
• Kemper Profiler
  ;Delay: Bypassed
  24 KB (3,721 words) - 12:54, 8 August 2023
• GK 250 ML
  is like a reverb/delay with no control over parameters. When hooked
  3 KB (476 words) - 19:52, 26 December 2014
• ToneMatch Mixer ToneMatch Presets, zEQ, ParaEQ
  ...zEQ if necessary, ParaEQ if necessary, then I might add some effects like Delay or Reverb.
  3 KB (446 words) - 00:54, 4 July 2023
• T1 ToneMatch® Audio Engine / Routing Multiple Effects
  <li>Channel 3 - Delay</li>
  4 KB (493 words) - 04:55, 26 March 2017
• T1 ToneMatch® Audio Engine / Digital Delay for Second L1®
  #REDIRECT [[T1 ToneMatch® Audio Engine / Digital Delay for Second L1®]]
  73 bytes (10 words) - 04:43, 26 March 2017
• Bose T4S and T8S ToneMatch® Mixers Compared to Bose T1® ToneMatch Audio Engine
  * Tap-tempo delay
  3 KB (453 words) - 01:38, 17 May 2021

View (previous 20 | next 20) (20 | 50 | 100 | 250 | 500)