Search results

Jump to: navigation, search
  • ...ut to write new chapters. Groups like Oasis, Pearl Jam, Radiohead, U2, and other of today's top acts include Rickenbacker guitars in their musical arsenal.
    3 KB (388 words) - 14:25, 16 March 2019
  • ...bration of the slug against the cover, and to hold the slug in the bobbin. Other changes to the pickups followed (which were not intentional design changes, ...who had the magnet directly in the middle of the coil of wire, and on the other hand you had Gibson who used a steel pole in the middle of the coil of wire
    9 KB (1,518 words) - 18:45, 26 March 2017
  • # At this point, most people would put the T1® on the bracket and attach the other cables. #I insert all the other cables into the T1® before I put it on the bracket. I do it this way becau
    2 KB (397 words) - 05:11, 26 March 2017
  • <h3>What is the L1 Model 1S system and what makes it different from other L1 portable line array systems?</h3> ...can be used as an amplification system for keyboards, acoustic guitars and other instruments as part of a traditional back line.</p> </div>
    14 KB (2,381 words) - 05:47, 26 March 2017
  • ...rol the relative volumes. Vocal volume is set. You can raise and lower the other inputs on the TC-Helicon VoiceLive Play GTX. If I had to decide between one or the other (VoiceLive Play GTX or T1®) and we were talking strictly vocal effects (no
    4 KB (655 words) - 22:53, 28 March 2017
  • ...by ear and by watching frequency response, but they're subjective like any other audio. ...hin VL3's menus. We didn't put the modeling into a subset of parameters or other data location, we simply sat in a room with the amp if we could and twiddle
    4 KB (625 words) - 12:01, 20 September 2014
  • So, assuming the Bose L1 is simply faithfully reproducing a hum (that other acoustic amps may be filtering), and that the Palathetic pickup is humming ...the first two strings are considerably louder - 6-10dB estimate - than the other strings). Takamine USA tech support had no solution for this problem and ag
    6 KB (1,079 words) - 02:22, 27 December 2014
  • ...rol the relative volumes. Vocal volume is set. You can raise and lower the other inputs on the TC-Helicon Play Acoustic. If I had to decide between one or the other (Play Acoustic or T1®) and we were talking strictly vocal effects (not har
    5 KB (825 words) - 04:27, 26 March 2017
  • ...) and let that be amplified through the T1® Main output. Then connect the other half of the stereo pair to another T1® Channel. In this example I did that .... The correct setting for any particular source may be different from your other sources.
    7 KB (1,179 words) - 05:03, 26 March 2017
  • .... The correct setting for any particular source may be different from your other sources. .... The correct setting for any particular source may be different from your other sources.
    7 KB (1,177 words) - 04:14, 26 March 2017
  • ...ath ZED Sixty-14FX]. The principles presented here are applicable to many other mixers. Connect the Left output to one L1® Compact and the Right output to the other L1® Compact.
    1 KB (194 words) - 13:16, 25 June 2017
  • If you cycle the power off and back on, you can get the same result on the other channel, 1 or 2. ...o system more tolerant of heavy bass diminishes the overall performance in other ways. We don't have plans to change the sound profile of the S1 Pro system
    14 KB (2,204 words) - 22:04, 15 September 2021
  • ...eversed and when you try to combine the signals later they may cancel each other. ...d right) will have the polarity reversed. The two signals will cancel each other out.
    3 KB (500 words) - 22:20, 16 November 2019
  • Most small stereo mixers allow you to direct the inputs to one side or the other (two sides of the mixer). ...channel with two inputs), panning hard to one side means you will lose the other side of the stereo pair.
    1 KB (198 words) - 11:48, 1 September 2018
  • #* If you are running stereo, Pan one channel LEFT and the other channel RIGHT ...gives you the same functionality as using channel volume controls for the other channels.
    2 KB (374 words) - 17:38, 2 December 2018
  • ...r bare piezo pickups found in some guitars) up to line-level devices (like other mixers). .... The correct setting for any particular source may be different from your other sources.
    3 KB (508 words) - 06:27, 22 December 2018
  • ...and when to use these based on what other things are happening in the mix (other players or sound sources).
    1 KB (210 words) - 13:21, 21 January 2019
  • ...Aux Input Channel 9 leaves all eight full featured channels available for other inputs. You will need to control T1 Pan and Level using the T8S PAN/AUX set ...Aux Input Channel 9 leaves all eight full featured channels available for other inputs. You will need to control T1 Pan and Level using the T8S PAN/AUX set
    2 KB (333 words) - 11:04, 8 April 2019
  • ...nning multiple powered loudspeakers ({{L1}}, {{F1}}, {{S1}}, [[L1 Pro]] or other) ...reo mixer, this means every sound source is panned hard to one side or the other
    564 bytes (86 words) - 23:24, 11 June 2021
  • There are other keys to reset other parts of the KPA memory.<br>
    4 KB (666 words) - 19:29, 8 November 2020

View (previous 20 | next 20) (20 | 50 | 100 | 250 | 500)