Search results

Jump to: navigation, search

There is a page named "Guitar" on this wiki. See also the other search results found.

  • ...e done this in other years, but that was for a single performer (Voice and Guitar). I really wanted to get out of that pocket but there was no dissuading the ...s suggest some different Presets to try for the microphone on his acoustic Guitar. Then I got as far as telling him about the Scenes, and he created one on h
    9 KB (1,752 words) - 19:00, 4 January 2009
  • ...h so its sound pressure fall-off with distance is not as severe as, say, a guitar amp, but it's somewhat greater than an {{Model I}} or {{Model II}}. We have ...in did the same on a number of occasions. He's an experienced pro, playing guitar and singing to demonstrate for other audiences. As an audience member liste
    27 KB (4,306 words) - 01:35, 20 May 2021
  • ...can see it by sticking a small mirror (Like a woman's compact) inside the guitar and looking up under the fingerboard. There is a little hex connector there # If your guitar has too much front bow in its neck and you're trying to flatten its neck, t
    2 KB (411 words) - 18:47, 26 March 2017
  • [[Image:Tch-voicelive-3-front-guitar.jpg|right|300px]] === Guitar Amp Simulations ===
    4 KB (625 words) - 12:01, 20 September 2014
  • ...connected to your {{T1}}. For best results, you will want to activate the guitar amp simulators in the Boss ME-80. ...ty jack plug to the Boss ME 80 Record Out / Phones Jack. This turns on the guitar amp simulators. Then you can connect Left (MONO) output to {{Compact}} Chan
    1 KB (219 words) - 01:06, 28 March 2017
  • ...our {{T1}} or {{Compact}}. For best results, you will want to activate the guitar amp simulators in the Boss ME-80. ...ty jack plug to the Boss ME-80 Record Out / Phones Jack. This turns on the guitar amp simulators. Then you can connect Left (MONO) output to {{Compact}} Chan
    1 KB (204 words) - 01:04, 28 March 2017
  • ...e single 8-inch woofer goes down to 65 Hz, and this is fine for vocals and guitar. It was also good for pre-recorded music for backing tracks or background m ...an L1 for each performer. We would use up to four B1 bass modules for bass guitar or drums. When the B2 became available, we would use that.
    15 KB (2,619 words) - 15:00, 31 October 2023
  • ...s not to say that the L1 will get louder. Bass-heavy instruments like bass guitar and kick drum had a good tone at lower levels with, let's say, a single B1. ...om 1 B1 to 4 B1's and not hear a major difference from a vocal or acoustic guitar that really just goes down to 80hz or so.
    12 KB (2,063 words) - 13:56, 21 September 2023
  • If you play Guitar then you should be able to relate to the frequencies I will mention to desc ...low E string on an Electric Bass (an octive below our low E on an Acoustic Guitar).
    7 KB (1,241 words) - 00:41, 28 June 2018
  • === Guitar Tubes, Amps, Modellers === ...l the different tone methods that we discuss here on the forum - almost a "guitar clinic". For instance, maybe ASAT could set his rig up, and demo for 5 minu
    4 KB (677 words) - 05:43, 26 March 2017
  • ...he little guitar amp next to the L1 system that is being used for electric guitar. You will not get good results, due to self-feedback in the bass. Rather, s ...– Sing and play strongly. Don’t play too loud, like through a mic’d guitar amp, so that you interfere with and spoil the sound distributed by the Bose
    6 KB (1,016 words) - 21:04, 16 January 2023
  • * Low octave on the guitar is from 80 Hz to 160 Hz (E2 to E3), A2 is at 110 Hz * 2nd octave on the guitar is from 160 Hz to 320 Hz (E3 to E4), A3 is at 220 Hz
    6 KB (952 words) - 15:34, 8 June 2021
  • * Vocal plus Acoustic Guitar with Piezo pickup. ...e left side as you view this, and found it very bass heavy for my acoustic Guitar. My partner on the other side said it was a little boomy but not too bad. W
    4 KB (819 words) - 12:30, 9 April 2011
  • ...nter auditorium in January, 2008, Ken Jacob asked me to write about my one guitar-2 L1 setup used in the program. Here is my response to his request. ...rate signals. The Taylor and the baggs each has its own endpin jack on the guitar.
    3 KB (638 words) - 18:37, 26 March 2017
  • Brian Terry provided this information about his settings with his Pedal Steel Guitar and his {{Model II}} and {{T1}}. ...55944/m/3201046745?r=3691081875#3691081875 Bose amp System for Pedal Steel Guitar]
    2 KB (257 words) - 02:35, 21 May 2013
  • ...There tend to be two main directions in controlling Guitar sound via any pedal Very often the signal chain from guitar to Wah into a preamp creates more hiss
    30 KB (3,215 words) - 13:19, 12 November 2008
  • Tony participated in our early work to understand the electric guitar and how it could work with the L1 technology. He is a ferocious guitar player and singer, and an excellent songwriter. He's a total Pro.
    6 KB (1,094 words) - 11:00, 24 April 2011
  • ...d again. It just seems that shaving bridge material with the bridge on the guitar is a bit aggressive. ...f "internet forum readers" who believe it is not a valid way to adjust the guitar. Both Jean and I, Taylor, Martin, Collings, and virtually every other maker
    2 KB (439 words) - 18:43, 26 March 2017
  • ..., this guitar was crafted from the ground up to be the "ultimate" players' guitar! ...nian cities. Lancaster just sounded like the perfect name for an "S" style guitar.
    6 KB (926 words) - 18:46, 26 March 2017
  • ...o S1 Pro channel 2 and use a Preset that is appropriate for the input (Mic Guitar Off). ...f the inputs are acoustic guitars with pickups set the ToneMatch switch to Guitar
    3 KB (485 words) - 22:23, 16 November 2019

View (previous 20 | next 20) (20 | 50 | 100 | 250 | 500)