L1 Pro to S1 Pro+
To connect an L1 Pro system to an S1 Pro+ as a monitor or an extension to the L1 Pro
- Use an XLR female to 1/4 inch (6.3 mm) Tip-Ring-Sleeve to connect the L1 Pro Line Out to the S1 Pro+ input three. You can also connect to channels 1 or 2, but using channel 3 is preferred because this gives the best match to the output level of the L1 Pro.
- Note: The L1 Pro Line Output (XLR) is LINE LEVEL, so connect it to one of the S1 Pro+ 1/4 inch (6.3 mm) inputs. These are also LINE LEVEL.
- The S1 Pro XLR inputs are MICROPHONE LEVEL, and the L1 Pro LINE LEVEL output may be too hot for the XLR inputs. If the S1 Pro+ input is clipping (RED LED), turn down the channel volume.
- Set the volume on the S1 Pro+ to 10:00 o'clock and then adjust it to suit the application. If you see solid red on the S1 Pro+, turn down the channel volume.
- Note
The L1 Pro Line Out is post-fader. It is the combined signal of all inputs and ToneMatch processing, EQ and Reverb. That includes inputs, 1, 2, 3, Bluetooth, and ToneMatch Port (used for T4S/T8S ToneMatch® Mixers).
The Line Out is pre-System EQ. That is, the signal at the Line Out is flat. It is not affected by the setting of the System EQ switch. [1]
This applies to any L1 Pro system (L1 Pro8, L1 Pro16, L1 Pro32).
