Search results

Create the page "Balanced" on this wiki! See also the search results found.

• Bose L1 Pro8 Compared to L1 Pro16
  XLR / 6 mm (1/4" Tip-Ring or Tip-Ring-Sleeve) balanced / unbalanced ...<li>6 mm (1/4" Tip-Ring or Tip-Ring-Sleeve) balanced / unbalanced</li>
  12 KB (941 words) - 15:01, 12 June 2021
• Bose L1 Pro16 Compared to L1 Pro32
  XLR / 6 mm (1/4" Tip-Ring or Tip-Ring-Sleeve) balanced / unbalanced <li>6 mm (1/4" Tip-Ring or Tip-Ring-Sleeve) balanced / unbalanced</li>
  13 KB (1,143 words) - 16:24, 23 September 2023
• Mixer / Mackie / 1402-VLZ3
  * If you want to use the Balanced XLR outputs use the MIC setting in the picture above. ==== XLR (balanced) to XLR (balanced) ====
  1 KB (225 words) - 11:36, 2 November 2010
• L1® T1 ToneMatch® Audio Engine / FAQ
  ...rs or recording devices. Preamp outputs for channels 1-3 accept a 1/4" TRS balanced phone plug cable. ...ly connect multiple sources with the added flexibility of accepting either balanced XLR audio cables or 1/4" TS unbalanced phone plug cables.
  31 KB (4,908 words) - 04:28, 9 April 2017
• T1 ToneMatch® Audio Engine / Aux
  The Aux Out is balanced mono and suitable to connect to the {{S1}} Channel 1 or 2. The Aux Out is balanced mono intended to be connected to the balanced input of another device at line-level. This may also work with headphones b
  5 KB (923 words) - 20:02, 9 July 2018
• ToneMatch® Cable
  ...ply, and then run a balanced line from the Master Out on the {{T1}} to the balanced 'analog input' on the {{Model II}}. This method would be able to transmit o ; ¼ Inch Tip-Ring-Sleeve (balanced) to ¼ Inch Tip-Ring-Sleeve (balanced)
  5 KB (805 words) - 19:12, 6 June 2021
• Mixer / Mackie / 802-VLZ3
  * If you want to use the Balanced XLR outputs use the MIC setting in the picture above. ==== XLR (balanced) to XLR (balanced) ====
  1 KB (218 words) - 11:45, 2 November 2010
• Audiopile: Cables for the L1® Family of Products / Review
  ...simply because that is what I had lying around. I have wanted to get some balanced &frac14; inch jack {{trs} connector cables for longer runs and for [[Compac <td>I got a couple of thirty foot &frac14; inch jack tip-ring-sleeve balanced cables. In the past I have used an old guitar wireless rig to do remote con
  12 KB (2,058 words) - 05:45, 26 March 2017
• T4S/T8S ToneMatch® Mixer
  ...llent quality audio whether you use the ToneMatch cable (T1® or T4S) or a balanced cable (T8S) for audio. If you are using good quality balanced cables there should be no difference between using any combination of XLR a
  9 KB (1,484 words) - 23:55, 13 December 2023
• Bose L1 Pro8 Compared to L1 Compact
  XLR / 6 mm (1/4" Tip-Ring or Tip-Ring-Sleeve) balanced / unbalanced <li>6 mm (1/4" Tip-Ring or Tip-Ring-Sleeve) balanced / unbalanced</li>
  7 KB (1,045 words) - 15:04, 12 June 2021
• TRS
  2. '''Ring:''' Right-hand channel for stereo signals, negative phase for balanced mono signals, power supply for power-requiring mono signal sources<br> 3. '''Tip''': Left-hand channel for stereo signals, positive phase for balanced mono signals, signal line for unbalanced mono signals<br>
  975 bytes (127 words) - 01:22, 12 July 2014
• Mixer / Allan & Heath / MixWizard WZ3
  === XLR Balanced +4 === ''AB OUT A pair of impedance balanced TRS jacks can be configured to provide an additional LR mix or engineers mo
  3 KB (411 words) - 15:58, 21 September 2012
• T1 ToneMatch® Audio Engine
  *Balanced XLR ...nduced noise or potential ground loop hum as you will if you plug into the balanced inputs (4,5).
  13 KB (1,983 words) - 11:55, 22 May 2018
• Mixer / Alto / L-12
  ==== XLR (balanced) to XLR (balanced) ==== (balanced to balanced) should be fine. This is the same kind of cable you would use to connect a
  2 KB (281 words) - 02:07, 23 October 2010
• Denon DN-MC6000
  [[Image:Compact Channel 2 Balanced.png]] ...erting XLR to 1/4 TRS. This cable is typically used to plug XLR cord into balanced 1/4" TRS panel jacks commonly found on mixing consoles and processing equip
  4 KB (625 words) - 14:05, 11 September 2014
• Mackie ProFX 12 to L1® Compact
  ...alanced.29">¼ Inch Tip-Ring-Sleeve (balanced) to ¼ Inch Tip-Ring-Sleeve (balanced)</span></h4> <p>A balanced connection is preferred and will provide better noise rejection over greate
  3 KB (534 words) - 17:10, 6 April 2017
• Bose S1 Pro Compared to Bose L1® Compact
  XLR / 6 mm (1/4" Tip-Ring or Tip-Ring-Sleeve) balanced / unbalanced XLR / 6 mm (1/4" Tip-Ring or Tip-Ring-Sleeve) balanced / unbalanced
  6 KB (861 words) - 01:41, 7 March 2022
• Bose L1 Model II Compared to L1 Pro32
  <li>6 mm (1/4" Tip-Ring or Tip-Ring-Sleeve) balanced / unbalanced</li> XLR / 6 mm (1/4" Tip-Ring or Tip-Ring-Sleeve) balanced / unbalanced
  11 KB (979 words) - 16:27, 23 September 2023
• Bose L1 Model 1S Compared to L1 Pro16
  <td>Line In: 6 mm (1/4" Tip-Ring or Tip-Ring-Sleeve) balanced / unbalanced Line-Level XLR / 6 mm (1/4" Tip-Ring or Tip-Ring-Sleeve) balanced / unbalanced
  11 KB (856 words) - 21:13, 11 June 2021
• Mixer / Mackie / CFX MkII
  === XLR Balanced +4 ===
  735 bytes (96 words) - 03:09, 21 December 2008

View (previous 20 | next 20) (20 | 50 | 100 | 250 | 500)