View source for Instruments / Drums

[[Image:GretchDrums.gif]][[Image:Percussion.gif]][[Image:TrapKat.gif]][[Image:VDrums.gif]]

== Out-of-Phase Overheads ==

Originally posted by Cliff-at-Bose: in Out of Phase Overheads <ref>[http://bose.infopop.cc/eve/forums/a/tpc/f/8566055944/m/4341033052/r/3781073052#3781073052  Cliff-at-Bose: in Out of Phase Overheads Original post in the Bose® Musicians Community Message Boards]</ref> 
[[Image:Male2Female_XY.gif|Two Female to Male XLR|right]]
These are not "overheads" but 57's placed below the cymbals and above the top heads of a small kit. The mics are wired out of phase, basically 2 and 3 reversed on an XLR. There's lots written about this on our forum. But the basic idea is that the pair will cancel onstage bass but pick up local instruments on the kit, in an effort to reduce rebroadcasting onstage bass from the drum mics. This way we get a stronger signal than typical overheads and cleaner bass onstage. To "mix" these, just move the mics closer to the instrument you want to emphasize. Typical setup is on either side of the snare facing the snare. Snare is everywhere and there is no need to put a mic directly on it. It's actually pretty easy to set up and adjust, moving the mics around for a good kit mix. With 3 mics and only 2 inputs on the PS1, we get a really nice amplified sound for our shows. I listened to the output of the pair recently (multitrack recordings of a recent show) and the cancelling thing really works great. Give it a try. 

Hilmar-at-Bose talks about Wiring Two SM75s with a Y cord <ref>[http://bose.infopop.cc/eve/forums/a/tpc/f/3976055944/m/1441055631/r/1441055631 Hilmar-at-Bose talks about Wiring Two SM75s with a Y cord  Original post in the Bose® Musicians Community Message Boards]</ref> 

Here's the nerds view.

Wiring the the two mics out of phase creates essentially a "dipole". Everything that is in the middle (i.e. equal distance) between the two microphones will get equally but out-of-phase so it cancels when the two microphone signals are summed together. In essence it creates a "blind spot" for the microphones for whatever is right in the middle plane. For the drums, that's mainly the kick (as Larry pointed out) and also the drummer (when he/she is hemming and hawing, squeaking with the chair, yelling about or in general having a grand old time).
Another nice trick is to place the L1 that gets the mic signal somewhere the middle plane of the microphones. This drastically reduces potential for feedback and unwanted regeneration.
Sound sources that are significantly closer to any one of the microphones are not much affected by the whole procedure.

[http://bose.infopop.cc/eve/forums/a/tpc/f/3976055944/m/1441055631?r=1441055631#1441055631 the original discussion]] &larr; is highly recommended.



[[category:Drums]]

[[category:Instruments]]

----
<references/>