Difference between revisions of "External Subwoofers"
m ({{L1 nl}}) |
m (formatting) |
||
| Line 1: | Line 1: | ||
| − | |||
=== Passive (unpowered) Loudspeakers === | === Passive (unpowered) Loudspeakers === | ||
{{Classic icon}}{{Model I icon}}{{Model II icon}} | {{Classic icon}}{{Model I icon}}{{Model II icon}} | ||
Revision as of 12:49, 12 January 2009
Contents
Passive (unpowered) Loudspeakers
Using loudspeakers other than the B1 Bass Module with any of the L1® systems is not supported. However you can safely try your own external subs if the impedance is no lower then 4 ohms (typically a single 4 ohm loudspeaker or two 8 ohm loudspeakers in parallel). The output from the Power Stand is 250 watts RMS into 4 ohms.
L1® Classic and L1® Model I
L1® Model II
Active (powered) Loudspeakers
Using powered loudspeakers with any of the L1® systems is not supported.
PackLite® power amplifier Model A1
The PackLite® power amplifier Model A1 is part the L1® System. It can be used to power up to two B1 Bass Modules. This is connected to the Power Stand Bass Line Out.
Third Party (non-Bose®) Systems
If you want to use a powered loudspeaker system, you can use the Power Stand Bass Line Out as the signal source. Here are notes specific to the L1® you are using.
You will probably use an powered loudspeaker in the same way as you would connect an PackLite® amp.
Please see PackLite® power amplifier Model A1 for extensive notes that include ideas that can be applied to other systems.