Difference between revisions of "Denon DN-MC6000"
m |
m |
||
| Line 6: | Line 6: | ||
| − | Running mono, set the output to MONO above and connect to the [[L1%C2%AE_Model_II#Analog_Input Model II Analog input]] or [[L1%C2%AE_Model_1S#Analog_Input Model 1S Analog input]] | + | Running mono, set the output to MONO above and connect to the [[L1%C2%AE_Model_II#Analog_Input|Model II Analog input]] or [[L1%C2%AE_Model_1S#Analog_Input|Model 1S Analog input]] or [[L1®_Compact#Channel_2|Compact Channel 2]] |
[[http://toonz.ca/bose/wiki/images/b/b6/Model_1S_Analog_Input_Detail.png]] | [[http://toonz.ca/bose/wiki/images/b/b6/Model_1S_Analog_Input_Detail.png]] | ||
Revision as of 03:42, 6 December 2013
Suggestions for connecting the Denon DN-MC6000 Professional DJ Multi-controller to an L1® Model 1S, Model II, or Compact.
See the diagram below (from Denon DN-MC6000 Professional DJ Multi-controller manual: Page 10)
Running mono, set the output to MONO above and connect to the Model II Analog input or Model 1S Analog input or Compact Channel 2
[[1]]
![[1]](http://toonz.ca/bose/wiki/images/b/b6/Model_1S_Analog_Input_Detail.png){kind=link}
With a cable like this:
Technical Description:
The EWI MP-105 is a special application adaptor cable for converting XLR to 1/4 TRS. This cable is typically used to plug XLR cord into balanced 1/4" TRS panel jacks commonly found on mixing consoles and processing equipment.
The Female XLR end is wired through to the 1/4" Male TRS end as follows:
- Pin One FXLR to Sleeve of MTRS
- Pin Two FXLR to Tip of MTRS
- Pin Three FXLR to Ring of MTRS
The 1/4" MTRS end is an EWI model P292S-BKG
The FXLR end is an EWI model ES3FB-GDP
The cable itself is constructed with 99.98% pure 22ga. high strand count copper conductors.