Difference between revisions of "Limiter"
m (Redirecting to Limiter in the L1®) |
m (Redirecting to Limiter in the L1®) |
||
| (One intermediate revision by the same user not shown) | |||
| Line 1: | Line 1: | ||
#REDIRECT [[Limiter in the L1®]] | #REDIRECT [[Limiter in the L1®]] | ||
| − | + | On the {{Forum}} you will read about "compression" when the L1™ is operating at high volume. | |
| + | |||
Hilmar-at-Bose tells us: | Hilmar-at-Bose tells us: | ||
| Line 17: | Line 18: | ||
[http://bose.infopop.cc/eve/forums/a/tpc/f/76010377/m/2180022266?r=2030042266#2030042266 Original Post] | [http://bose.infopop.cc/eve/forums/a/tpc/f/76010377/m/2180022266?r=2030042266#2030042266 Original Post] | ||
| − | |||
| − | |||
Latest revision as of 20:11, 22 March 2014
Redirect to:
On the Bose® Pro Portable PA Community you will read about "compression" when the L1™ is operating at high volume.
Hilmar-at-Bose tells us:
- There is no actual compressor. The only dynamic processing is a protective limiter. That should only kick in, when you are hitting it real hard.
- This limiter is not per-se frequency dependent, but there are independent ones for the L1 and B1 and they are tuned a little different.
Julio-at-Bose
- Model II limiter
- The limiters threshold is from -50.0dB to 0dB. A limiter is a type of compressor to limit the level of a signal to a certain threshold. A limiter will almost completely prevent any additional gain above the threshold. Limiters are used against signal peaking (clipping). They prevent occasional signal peaks which would be too loud or distorted.