Difference between revisions of "T4S to F1 Model 812 Tip Ring Sleeve Connection"
m |
m |
||
(One intermediate revision by the same user not shown) | |||
Line 1: | Line 1: | ||
== Connect the T4S to {{F1}} == | == Connect the T4S to {{F1}} == | ||
+ | |||
+ | Connect a ToneMatch Power Supply to the ToneMatch port on the T4S. Then | ||
[[File:T4S to F1 Model 812 TRS x 2.jpg|600px]] | [[File:T4S to F1 Model 812 TRS x 2.jpg|600px]] | ||
Line 7: | Line 9: | ||
Connect the ToneMatch Power Supply to the {{T4S}} for power. | Connect the ToneMatch Power Supply to the {{T4S}} for power. | ||
+ | Note: If you have only one {{F1}} use the T4S output marked Right/Mono. | ||
== Gain Staging == | == Gain Staging == |
Latest revision as of 20:19, 13 January 2023
Contents
Connect the T4S to F1 Model 812 Flexible Array Loudspeaker
Connect a ToneMatch Power Supply to the ToneMatch port on the T4S. Then
The output from the T4S ToneMatch mixer is a balanced mono 1/4 inch (6.35 mm) Tip-Ring-Sleeve and the input on the F1 Model 812 Flexible Array Loudspeaker is a balanced mono 1/4 inch (6.35 mm) Tip-Ring-Sleeve so use a cable like this.
1/4" TRS Balanced Patch Cable (audiopile.net)
Connect the ToneMatch Power Supply to the T4S ToneMatch mixer for power.
Note: If you have only one F1 Model 812 Flexible Array Loudspeaker use the T4S output marked Right/Mono.
Gain Staging
For each F1 Model 812 Flexible Array Loudspeaker
F1 Model 812 Flexible Array Loudspeaker Channel 1 Combo Input
The use a ¼ inch Tip-Ring-Sleeve jack cable.
MIC / LINE LEVEL
Set this to LINE LEVEL
Volume Control
Use the Input 1 volume control.
- Set the Input 1 Volume control to the 0 (zero) position.
- Connect the T4S ToneMatch mixer Main Output to the Input 1
- Adjust the volume of the T4S ToneMatch mixer Main Output to the maximum output without distortion. This is probably between 10:00 o'clock and 12:00 o'clock on the Master Output
- While playing music through the T4S ToneMatch mixer, increase the Volume level so that the Signal/Clip indicator glows green with flickers of red. This will probably be around 9:00-11:00 o'clock
- If the Signal/Clip indicator glows red, decrease the Volume level so that it glows only green or red. If you see red flashes longer than one second, turn down the volume.