Difference between revisions of "Limiter in the L1®"

From Bose Portable PA Encyclopedia
Jump to: navigation, search
m
m
Line 16: Line 16:
 
[http://bose.infopop.cc/eve/forums/a/tpc/f/76010377/m/2180022266?r=2030042266#2030042266 Original Post]
 
[http://bose.infopop.cc/eve/forums/a/tpc/f/76010377/m/2180022266?r=2030042266#2030042266 Original Post]
  
 +
{{L1 Limiter}}
  
Limiter in the L1® (applies to all L1 and L1 Pro Models) {{L1 Pro icon}}{{Model II icon}}
 
 
:When you are running your L1® at maximum output and you introduce something else like a voice the limiter may kick in to prevent distortion and prevent damage. As a result the the level of the entire system is reduced. The addition of your voice is what is putting the system into the limiting state.
 
 
:You may noticing the limiter on the music and not your voice  because when you talk or sing the entire level of the system comes down by "x"dB and but your voice level will still be relative to the music based on your mixer setting.
 
 
:When you stop talking the limiter disengages and ramps the music back up to the level it was before you started talking. Essentially the limiter releases and allows the audio to come back to max level.
 
 
Reference [http://bose.infopop.cc/eve/forums/a/tpc/f/867107664/m/5651045245?r=5031038345#5031038345 Craig-at-Bose talks about the "Compressor / Limiter Problem"].
 
 
Related discussion: [https://support.bose.com/s/display-articles?productId=01t8c00000OydHUAAZ&articleId=ka08c000001g6ulAAA&language=en_CA  Low audio from product - L1 Pro16]
 
  
 
<!--
 
<!--

Revision as of 19:55, 13 September 2024

Hilmar-at-Bose tells us:

There is no actual compressor. The only dynamic processing is a protective limiter. That should only kick in, when you are hitting it real hard.
This limiter is not per-se frequency dependent, but there are independent ones for the L1 and B1 and they are tuned a little different.

Original Post

Julio-at-Bose

Model II limiter
The limiters threshold is from -50.0dB to 0dB. A limiter is a type of compressor to limit the level of a signal to a certain threshold. A limiter will almost completely prevent any additional gain above the threshold. Limiters are used against signal peaking (clipping). They prevent occasional signal peaks which would be too loud or distorted.

Original Post

Limiter in the L1® (applies to all L1 and L1 Pro Models)

L1 Pro This information is applicable to the L1 Pro
L1 Model II This information is applicable to the L1®  Model II

When you are running your L1® at maximum output and you introduce something else like a voice the limiter may kick in to prevent distortion and prevent damage. As a result the the level of the entire system is reduced. The addition of your voice is what is putting the system into the limiting state.
You may noticing the limiter on the music and not your voice because when you talk or sing the entire level of the system comes down by "x"dB and but your voice level will still be relative to the music based on your mixer setting.
When you stop talking the limiter disengages and ramps the music back up to the level it was before you started talking. Essentially the limiter releases and allows the audio to come back to max level.

Source: Craig-at-Bose

Related discussion: Low audio from product - L1 Pro16





Keywords: Limiter Compressor Ducking side-chain