Difference between revisions of "L1 Pro to S1 Pro"
m |
m |
||
| (2 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
{{L1 Pro icon}} {{S1 Pro icon}} | {{L1 Pro icon}} {{S1 Pro icon}} | ||
| − | To connect an L1 Pro system to an {{S1 Pro}} as a monitor or an extension | + | To connect an L1 Pro system to an {{S1 Pro}} as a monitor or an extension to the L1 Pro |
#Use an XLR female to 1/4 inch (6.3 mm) Tip-Ring-Sleeve to connect the L1 Pro Line Out to the {{S1 Pro}} inputs one or two | #Use an XLR female to 1/4 inch (6.3 mm) Tip-Ring-Sleeve to connect the L1 Pro Line Out to the {{S1 Pro}} inputs one or two | ||
| − | * Note: The L1 Pro Line Output (XLR) is LINE LEVEL so | + | #* Note: The L1 Pro Line Output (XLR) is LINE LEVEL so connect it to one of the S1 Pro 1/4 inch (6.3 mm) inputs. These are also LINE LEVEL. |
| + | #* The {{S1 Pro}} XLR inputs are MICROPHONE LEVEL, and the L1 Pro LINE LEVEL output may be too hot for the XLR inputs. If you see solid red on the {{S1 Pro}} turn down the channel volume. | ||
#Set the volume on the {{S1 Pro}} to 10:00 o'clock and then adjust to suit the application. If you see solid red on the {{S1 Pro}} turn down the channel volume. | #Set the volume on the {{S1 Pro}} to 10:00 o'clock and then adjust to suit the application. If you see solid red on the {{S1 Pro}} turn down the channel volume. | ||
Latest revision as of 12:11, 26 September 2024
To connect an L1 Pro system to an S1 Pro system as a monitor or an extension to the L1 Pro
- Use an XLR female to 1/4 inch (6.3 mm) Tip-Ring-Sleeve to connect the L1 Pro Line Out to the S1 Pro system inputs one or two
- Note: The L1 Pro Line Output (XLR) is LINE LEVEL so connect it to one of the S1 Pro 1/4 inch (6.3 mm) inputs. These are also LINE LEVEL.
- The S1 Pro system XLR inputs are MICROPHONE LEVEL, and the L1 Pro LINE LEVEL output may be too hot for the XLR inputs. If you see solid red on the S1 Pro system turn down the channel volume.
- Set the volume on the S1 Pro system to 10:00 o'clock and then adjust to suit the application. If you see solid red on the S1 Pro system turn down the channel volume.
- Note
The L1 Pro Line Out is post-fader. That is, it is the combined signal of all inputs and ToneMatch processing, EQ and Reverb. That includes inputs, 1, 2, 3, Bluetooth, and ToneMatch Port (used for T4S/T8S ToneMatch® Mixers).
The Line Out is pre-System EQ. That is, the signal at the Line Out is flat. It is not affected by the setting of the System EQ switch. [1]
This applies to any L1 Pro system (L1 Pro8, L1 Pro16, L1 Pro32).
