Difference between revisions of "S1 Pro to L1 Model I"
(Created article) |
m (Text replacement - "Category:S1" to "Category:S1 Pro") |
||
| (One intermediate revision by the same user not shown) | |||
| Line 7: | Line 7: | ||
Connect {{S1}} to {{Model I}} | Connect {{S1}} to {{Model I}} | ||
| − | You can connect to the S1 Pro system as you would when using it alone. Then run a cable from the S1 Pro Line Out to any of the 1/4" inputs on the L1 Model I. You can use an ordinary Tip-Sleeve instrument cable. | + | You can connect to the S1 Pro system as you would when using it alone. Then run a cable from the S1 Pro Line Out |
| + | |||
| + | {{S1 Pro Line Out}} | ||
| + | |||
| + | |||
| + | to any of the 1/4" inputs on the L1 Model I. You can use an ordinary Tip-Sleeve instrument cable. | ||
| + | |||
| + | [[File:L1 Model I 14 inputs.jpg]] | ||
If you use the L1 Model I inputs on channels 1 or 2, set the Preset to 00. Set the input trim so that when you are running the S1 Pro at the loudest you will perform, the L1 Model I Signal/OL lights are solid green. Occasional red flickers are okay. | If you use the L1 Model I inputs on channels 1 or 2, set the Preset to 00. Set the input trim so that when you are running the S1 Pro at the loudest you will perform, the L1 Model I Signal/OL lights are solid green. Occasional red flickers are okay. | ||
| + | [[File:SignalOLLED.png]] | ||
| Line 22: | Line 30: | ||
[[Category:How To]] | [[Category:How To]] | ||
| − | [[Category:S1]] | + | [[Category:S1 Pro]] |
[[Category:Model I]] | [[Category:Model I]] | ||
[[Category:Connections]] | [[Category:Connections]] | ||
}} | }} | ||
Latest revision as of 21:20, 16 November 2019
If you want to use your S1 Pro System as a monitor and use an L1 Model I as the Front of House system you can connect your microphone and instrument to the S1 Pro System and connect the S1 Pro System to the L1 Model I
How To
Connect S1 Pro System to L1 Model I
You can connect to the S1 Pro system as you would when using it alone. Then run a cable from the S1 Pro Line Out
The S1 Pro System Line Out is post Volume, Tone, and ToneMatch presets on channels 1 and 2. It also includes the post volume signal from channel 3.
to any of the 1/4" inputs on the L1 Model I. You can use an ordinary Tip-Sleeve instrument cable.
If you use the L1 Model I inputs on channels 1 or 2, set the Preset to 00. Set the input trim so that when you are running the S1 Pro at the loudest you will perform, the L1 Model I Signal/OL lights are solid green. Occasional red flickers are okay.
Additional Information
Note: All the 1/4" inputs on the L1 Model I are unbalanced. That means, there's no need or advantage to using a balanced Tip-Ring-Sleeve cable. Also, if you use a 1/4" Tip-Ring-Sleeve to XLR cable into channels 1 or 2, you may find it difficult to do the gain staging because the signal from the S1 Pro may be too hot for the XLR inputs.