Difference between revisions of "Mixer / Yamaha / MG124 CX"
m |
m |
||
| Line 14: | Line 14: | ||
===== ¼ Inch Tip-Ring-Sleeve (balanced) to ¼ Inch Tip-Ring-Sleeve (balanced) ===== | ===== ¼ Inch Tip-Ring-Sleeve (balanced) to ¼ Inch Tip-Ring-Sleeve (balanced) ===== | ||
| + | The output of this mixer is balanced, and the input on the Model II Power Stand is also balanced, so this is the preferred method. | ||
| + | |||
[[Image:trsMtrsM.png|Tip-Ring-Sleeve to Tip-Ring-Sleeve]] | [[Image:trsMtrsM.png|Tip-Ring-Sleeve to Tip-Ring-Sleeve]] | ||
===== ¼ Inch Tip-Sleeve (unbalanced) to ¼ Inch Tip-Sleeve (unbalanced) ===== | ===== ¼ Inch Tip-Sleeve (unbalanced) to ¼ Inch Tip-Sleeve (unbalanced) ===== | ||
| + | |||
[[Image:TsMtsM.png|Tip-Sleeve to Tip-Sleeve]] | [[Image:TsMtsM.png|Tip-Sleeve to Tip-Sleeve]] | ||
===== ¼ Inch Tip-Ring-Sleeve (balanced) to ¼ Inch Tip-Sleeve (unbalanced) ===== | ===== ¼ Inch Tip-Ring-Sleeve (balanced) to ¼ Inch Tip-Sleeve (unbalanced) ===== | ||
| + | |||
[[Image:trsMtsM.png|Tip-Ring-Sleeve to Tip-Sleeve]] | [[Image:trsMtsM.png|Tip-Ring-Sleeve to Tip-Sleeve]] | ||
| − | + | ||
</td></tr></table> | </td></tr></table> | ||
Revision as of 11:46, 19 September 2012
To use a Yamaha MG124 CX Mixer with the L1 Model II
On the mixer
- pan all the inputs hard LEFT
- run a line out of the LEFT output to the Model II Power Stand Analog input (cable details below)
Contents
Cable Details
¼ inch jack inch to ¼ inch
|
This mixer has ¼ inch jack balanced outputs. Any of the cables shown below should work. |
¼ Inch Tip-Ring-Sleeve (balanced) to ¼ Inch Tip-Ring-Sleeve (balanced)The output of this mixer is balanced, and the input on the Model II Power Stand is also balanced, so this is the preferred method.
¼ Inch Tip-Sleeve (unbalanced) to ¼ Inch Tip-Sleeve (unbalanced)
¼ Inch Tip-Ring-Sleeve (balanced) to ¼ Inch Tip-Sleeve (unbalanced)
|
